Installing the Cisco SFS 7008P Switch into a Rack
Figure 8 | Management I/O Modules Located in the Back of the Unit |
Chassis ID
Power
plug
Management I.O
modules
Power
plug
2
4x copper line interface modules
1
Main air exhaust
144988
Configuring and Connecting Host Channel Expansion Card for IBM BladeCenter
This section briefly describes configuring your InfiniBand host. Download the configuration software and an integrated suite of drivers including IPoIB, SRP, SDP, uDAPL and MPI from the Cisco Software Center at this URL:
Install the Host Channel Expansion Card for IBM BladeCenter by doing the following:
Step 1 Power down the host system following proper grounding procedures.
Step 2 Unpack the HCA module and insert it into an open
Step 3 Power on the host system.
Installing Host Channel Expansion Card Linux Drivers
Make sure your Linux kernel is supported. See www.cisco.com for a list of supported versions.
| Cisco SFS 7008P InfiniBand Server Switch Installation and Configuration Note |
10 |