Cisco Systems SFS 7000 Configure Basic Connectivity, 9Secure the Switch Through the Front Posts

Page 28

6

4.Insert the switch into the rack with the rack brackets attached. You will have to tilt the switch unit to one side to avoid hitting the sides of the rack with the brackets as the pass around the back posts.

Return the switch unit to a horizontal position once the switch is inside the rack. The rear rack brackets flanges should wrap around the outside of the back rack posts.

5.Have one person hold the switch while another person secures the switch to the rack.

6.Attach the back rack brackets to the back of the posts with screws that fit your rack.

7.Attach the front rail brackets to the front of the rack posts with screws that fit your rack, as shown in Figure 1-9.

Figure 1-9:Secure the Switch Through the Front Posts

Configure Basic Connectivity

1.Attach an RJ-45 console cable

a.Connect the cable from the InfiniBand chassis serial console to your terminal or management workstation; use the cable kit that is provided in the package.

For detailed information on how to connect the serial console cable, please see the documentation included with the serial cable kit.

b.Open a terminal emulation window using a program such as HyperTerminal for Windows. Set your terminal parameters to the following:

Baud: 9600 bps

Data Bits: 8

Parity: None

Stop Bits: 1

Flow control: None

2.Attach the power cables and power on the chassis

For more information, see the Topspin 120 Hardware Guide.

c.Insert the power cords. The Topspin 120 system will automatically boot up. You can watch the running status via the serial console.

3.Configure an IP address for the Ethernet management port

It is necessary to configure connectivity to the out-of-box Etherent management port in order to use Telnet or the GUI. The system is not pre-configured when it ships from the factory.

d.When the system has completed booting, press Enter several times to display the CLI prompt.

Login:

Image 28
Contents Part Number OL-7723-01 Product ID Page Terms and Conditions of Sale for Page FCC Statement Safety Information Regulatory NoticesPage Contact Information General CautionsViii Topspin 120 Contents List Page Product Registration Thank YOU for Purchasing Your Topspin ProductXii Terms and Conditions of Sale for Topspin Communications, Inc Xiv Page Xvi Xvii Xviii Topspin Limited End User Warranty Extent of Limited WarrantyHow to Obtain Warranty Service Limitations of LiabilityDeclaration of Conformity Table VIII-1 StandardsXxii Prepare the Site Topspin 120 Quick StartMount the Chassis in a Rack Rack Mount Installation Flange 3Holding Rack Bracket Against Inside of Rack Installing the Switch with Two People Configure Basic Connectivity 9Secure the Switch Through the Front PostsConfigure and Connect InfiniBand Hosts Topspin-120config#interface mgmt-ethernet# mount /mnt/cdrom 10Fully Installed IB Cable with Pinch Connector 12Removing a Pinch Connector Optional Launch the Chassis Manager Prepare Your Device14Web Browser Window Optional Install the Element Manager GUI Programs -Topspin Element Manager -TopspinEMPage Index Http