11
(Optional) Launch the Chassis Manager
Chassis Manager is a
Prepare Your Device
To launch Chassis Manager on your Topspin 270, you must:
•Configure an IP address on the Ethernet management port, if you have not already done so.
•Configure an IP gateway on the Ethernet management port, if you have not already done so.
•Optional. Enable Telnet services (Telnet services should be enabled by default).
•Enable HTTP and/or HTTPs services (HTTP services should be enabled by default).
If you followed the previous steps, you should already have these items configured. If your device meets these requirements, proceed to “Launch Chassis Manager” on page 11. Otherwise, to prepare your device, perform the following steps:
NOTE: Consult your network administrator for an IP address, subnet mask, and gateway address before you begin this process.
1.If you have not yet configured an IP address for the Management port, refer to “Configure Basic Connectivity” on page 6.
2.Enter the telnet enable command in global config mode to start telnet services on your device. You may need to use the exit command to return to global config mode.
Example
3.Enter the ip http server command to enable HTTP services on your device. HTTPs is also supported.
Example
Launch Chassis Manager
To launch Chassis Manager, perform the following steps:
Launch your Web browser. Chassis Manager supports the following browsers
•Microsoft Internet Explorer version 6
•Netscape Navigator version 6
•Mozilla version 1.4