User Interface Commands
Administrator Password Commands
Use the commands in this section to configure hub passwords.
password
Syntax: password
Mode: Administrator
Description: Configures the password used to enter administrator mode.
After entering the command, you will be prompted to enter the current password and then the new password. You will then be prompted to confirm the new password. Password characters are represented by asterisks on the screen when you enter them, as shown below:
Hub# password
Old password: ********
New password: *******
Passwords can:
•Contain up to 14 characters.
•Contains any combination of alphanumeric characters, including uppercase and lowercase letters.
•Use spaces as valid characters.
no password
Syntax: | no password |
Mode: Administrator
Description: Deletes any password that has been set with the password command.
Using Your Hub Software