Cisco Systems 1503 manual Configuring Trap Managers, Show ip trap-managers, Ip trap-managers

Command Summary

Configuring Trap Managers

Use the commands in this section to configure the Micro Hub 1503 trap information. Trap information enables the hub to send information to connected network devices. These messages notify network devices about events on the network.

show ip trap-managers

Syntax: show ip trap-managers

Mode: Guest

Description: Displays information about authorized trap managers as shown in the following example:

Hub> show	ip trap-managers
Index IP	Address	Community Name Status

-----------------------------------------------

1	222.222.222.222	public	enabled
2	11.11.11.11	public	disabled
3	0.0.0.0	public	disabled
4	0.0.0.0	public	disabled
5	0.0.0.0	public	disabled

Command Display Definitions

•IP Address—IP address of the network management station.

•Community Name—Name used to identify an SNMP community.

•Status—Whether or not the community is enabled or disabled.

3-34Cisco Micro Hub User Guide