Cisco Systems 15454 specifications TXPMR10E-C, TXPMR10E-L, TXPMR2.5G

Page 9

Chapter 2 Cards Specifications

2.1 Card Overview

Table 2-5

Cisco ONS 15454 DWDM Cards (continued)

 

 

 

 

Card

 

Part Number

Description

 

 

 

 

TXP_MR_10E

 

15454-10E-L1-xx.x=

The 10 Gbps Transponder-100 GHz-Tunable xx.xx-xx.xx

 

 

 

(TXP_MR_10E) card has two sets of ports located on the faceplate

 

 

 

and can be installed in Slots 1 to 6 and Slots 12 to 17. It is a multirate

 

 

 

transponder for the ONS 15454 platform. It processes one 10-Gbps

 

 

 

signal (client side) into one 10-Gbps, 100-GHz DWDM signal (trunk

 

 

 

side) that is tunable on four wavelength channels (ITU-T 100-GHz

 

 

 

grid). Each version of this card has a different part number.

 

 

 

You can provision this card in a linear configuration, bidirectional line

 

 

 

switched ring (BLSR), a path protection, or a hub. The card can be

 

 

 

used in the middle of BLSR or 1+1 spans when the card is configured

 

 

 

for transparent termination mode.

 

 

 

The TXP_MR_10E port features a 1550-nm laser for the trunk port

 

 

 

and an ONS-XC-10G-S1 XFP module for the client port and contains

 

 

 

two transmit and receive connector pairs (labeled) on the card

 

 

 

faceplate.

 

 

 

The TXP_MR_10E card is tunable over four wavelengths in the

 

 

 

1550 nm ITU 100 GHz range. They are available in eight versions,

 

 

 

covering thirty-two different wavelengths in the 1550 nm range.

 

 

 

TXP_MR_10E-C

15454-10E-L1-C=

This transponder has the same features as the TXP_MR_10E card, but

 

 

 

its trunk interface can be tuned over the entire C band.

 

 

 

TXP_MR_10E-L

15454-10E-L1-L=

This transponder has the same features as the TXP_MR_10E card, but

 

 

 

its trunk interface can be tuned over the entire L band.

 

 

 

 

TXP_MR_2.5G

 

15454-MR-L1-xx.x=

The 2.5 Gbps Multirate Transponder-100 GHz-Tunable xx.xx-xx.xx

 

 

 

(TXP_MR_2.5G) card has two sets of ports located on the faceplate

 

 

 

and can be installed in Slots 1 to 6 and Slots 12 to 17. It processes one

 

 

 

8 Mbps to 2.488 Gbps signal (client side) into one 8 Mbps to 2.5 Gbps,

 

 

 

100-GHz DWDM signal (trunk side). It provides one long-reach

 

 

 

STM-16/OC-48 port per card, compliant with ITU-T G.707, ITU-T

 

 

 

G.709, ITU-T G.957, and Telcordia GR-253-CORE. Each version of

 

 

 

this card has a different part number.

 

 

 

The TXP_MR_2.5G card is tunable over four wavelengths in the

 

 

 

1550 nm ITU 100-GHz range. The card is available in eight versions,

 

 

 

covering thirty-two different wavelengths in the 1550 nm range. The

 

 

 

TXP_MR_2.5G card supports 2R (reshape and regenerate) and 3R

 

 

 

(retime, reshape and regenerate) modes of operation where the client

 

 

 

signal is mapped into a ITU-T G.709 frame.

 

 

 

 

Cisco ONS 15454 DWDM Engineering and Planning Guide, Release 7.x

 

July 2006

2-9

 

 

 

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Cards Specifications Band IDs Add/Drop Channel IDs Add/Drop Wavelengths nm AD-4C-xx.x Channel Sets Band IDs Add/Drop Channel IDs Add/Drop Wavelengths nm Oscm Card Part Number DescriptionOSC-CSM OPT-PREOPT-BST-L OPT-BST-EOPT-AMP-L 32MUX-OCisco ONS 15454 Dwdm Engineering and Planning Guide, Release 32WSS-L 32WSSMMU TXPMR10GTXPMR10E-C TXPMR10ETXPMR10E-L TXPMR2.5GTXPPMR2.5G MXPPMR2.5G MXPMR2.5G1.1 TCC2 Card Common Control CardsMXPMR10DMEC MXPMR10DMELTCC2 Block Diagram and Faceplate 1.2 TCC2P Card 2shows the faceplate and block diagram for the TCC2P cardTCC2P Block Diagram and Faceplate MS-ISC-100T Card MS-ISC-100T Faceplate and Block Diagram Parameter Condition Min Max Unit Optical Service Channel Cards3.1 32WSS Card Optical Add and Drop CardsLine OSC COM COM Line PMDMax Unit Parameter Condition MinParameter Condition Min Typical Max 3.2 32WSS-L CardParameter Condition Min Typical Max Unit 3.3 32DMX Card3.4 32DMX-L Card OUTPDL 12defines the optical parameters for the 32MUX-O card 3.5 32MUX-O CardParameter Min Typical Max Unit 3.6 32DMX-O Card14defines optical parameters for the 4MD-xx.xx card 3.7 4MD-xx.x CardOptical Parameters Value Band Oadm Filter CardsAD-2C-xx.x Card Optical Parameters EXP a RX = MMU CardCOM TX COM RX =EXP RX = EXP a RX Optical AmplifiersEXP RX = EXP B RX EXP B RXParameter Comment Min OPT-PRE CardParameter Comment Min Typical Max Unit OPT-BST and OPT-BST-E CardsFor detailed Pin-Pout power mask Single channel see DBm OPT-BST-E Card Standard and Extended Gain Range OPT-BST-L CardOPT-BST-L Card Standard and Extended Gain Range OPT-AMP-L Card OPT-BST-L Card Functional Block DiagramOsri ALS 10 OPT-AMP-L Card Standard and Extended Gain Range Receive Section Dispersion Compensation UnitsLeaf Fiber DCU Description BandDCU Mechanical Specifications DCU Optical SpecificationsUnits Specifications Dwdm 2.5-Gbps Dwdm 10-Gbps Dwdm 10-Gbps TXP/MXP Transponder, Muxponder, and Optical CardsFull C-Band Wavelength nm Ch TunableTXP/MXP TXP/MXP Wavelength nm Ch Tunable Full L-Band Tunable 6.1 OC48 ITU-T Optics Band SpectrumCards Channel nm Frequency THz Band Spectrum 6.2 OC192 ITU-T Optics Client Side Interfaces Ficon 1G SFP-GEFC-SX 15454E-SFP-GEFC-SXFicon 2G ONS-SE-2G-S1Client Interface SFP/XFP Cable Module10GBASE-LR 10GBASE-LR ONS-XC-10G-S1Parameter Conditions Min Parameter Conditions Min Typical MaxBay Frame Mechanical EquipmentOptical Shelf Dispersion Compensation Shelf8.6 32 Channel Patch-Panel Trays Fiber Storage15 32-Channel Patch Panel Shelf Fiber Routing
Related manuals
Manual 12 pages 4.75 Kb

15454 specifications

Cisco Systems' 15454 is a leading optical networking platform designed to address a range of connectivity needs for service providers, enterprises, and data centers. As part of the Cisco ONS (Optical Networking System) portfolio, the 15454 provides advanced capabilities that cater to the evolving demands of high-performance network requirements.

At its core, the Cisco 15454 is built for scalability and versatility. It supports a variety of transmission methods, including SONET (Synchronous Optical Networking), SDH (Synchronous Digital Hierarchy), and WDM (Wavelength Division Multiplexing). This flexibility makes the platform ideal for deploying both legacy services and next-generation applications.

One of the standout features of the 15454 is its ability to support high-capacity wavelengths, allowing for greater bandwidth utilization across fiber networks. With advanced Dense Wavelength Division Multiplexing (DWDM) technology, the platform ensures efficient use of the available fiber and extends the distance over which data can be transmitted. This results in reduced operational costs while maximizing throughput.

The Cisco 15454 also comes equipped with an array of interfaces supported by its modular design. The platform can accommodate Ethernet, SONET/SDH, and IP services, which means it can seamlessly handle a wide range of protocols. The modular architecture allows network operators to tailor the system to their specific requirements, offering a variety of line cards and interfaces to choose from.

Another critical characteristic of the 15454 is its built-in protection mechanisms. The system offers diverse and automatic protection schemes such as optical Layer 1 protection, ensuring high availability and network resilience. This capability is essential for mission-critical applications where uptime is paramount.

Moreover, the platform is complemented by Cisco's sophisticated management solutions, which streamline the operational management of the network. With tools that provide in-depth monitoring and troubleshooting capabilities, network administrators can maintain optimal performance and quickly respond to any issues that may arise.

In summary, the Cisco Systems 15454 is a robust and adaptable optical networking solution. Its main features, including advanced DWDM capabilities, modular architecture, protocol versatility, and enhanced protection mechanisms, make it a preferred choice for organizations looking to scale their network infrastructure while ensuring high service reliability and performance. Whether for expanding bandwidth or modernizing legacy networks, the Cisco 15454 stands out as a powerful tool in the ever-evolving landscape of telecommunications.
Top Page Image Contents