Cisco Systems WAE-7326-K9, WAE-7341-K9, WAE-7371-K9, WAE-611-K9, WAE-674-K9, WAE-511-K9 manual Front

Page 15

Installing Adapters in the WAE-512 and WAE-612 Appliances

Figure 8

Removing the Riser Card Assembly

1

Front

2

151927

Rear

1

Riser card assembly

2

Rear edge of riser card

Step 6 Place the riser card assembly on a flat, static-protective surface.

Step 7 Remove the expansion slot cover for Slot 1. (See Figure 9.)

Note You must install PCI expansion slot covers on all vacant slots so that you can maintain the electronic emissions characteristics of the appliance and ensure proper cooling of internal components.

Installing the Cisco WAE Inline Network Adapter

	OL-12480-03	15

Image 15

Contents Contents Inline Network Adapter Description Product OverviewLEDs State Description Ports and LED IndicatorsSpecification Description Adapter SpecificationsSafety Guidelines General Precautions Protecting Against Electrostatic Discharge Important Operational NotesStatement Removing the CoverInstalling an Inline Network Adapter Expansion slot cover slot Captive screw Riser card assembly Installing an Adapter in the Riser Card Assembly Install the appliance in the rack Completing the InstallationStatement Installing Adapters in the WAE-512 and WAE-612 AppliancesInstalling an Inline Network Adapter Front Installing the Adapter in the Riser Card Assembly Installing Adapters in the WAE-7326 Appliance To remove the device top cover, follow these steps PCI-X Riser Card Riser card cage Scsi cable Completing the Installation Cover-release latch Removing the PCI-X Riser-Card Assembly Inverted riser assembly Access holes Guide Release tabs Cabling Connection Required Cable Cable Requirements for WAE Connections Using Fast Ethernet Router a Cabling Between Two Inline WAEs Related Documentation OL-12480-03