Cisco Systems Installing Network Adapters for Cisco WAE 512 K9 and WAE 612 K9 Models
Page 22

Installing Adapters in the WAE-7371, WAE-7341, and WAE-674 Appliances

Installing Adapters in the WAE-7371, WAE-7341, and WAE-674 Appliances

This section describes how to install the inline network adapter in the WAE-7371, 7341, and 674 appliances. This section includes the following procedures:

•Removing the Cover

•Installing an Inline Network Adapter

•Completing the Installation

Removing the Cover

Warning Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord.

Statement 1

To remove the device top cover, follow these steps:

Step 1 Review the information in the “Safety Guidelines” section on page 5.

Step 2 Power off the device and all attached devices and disconnect all external cables and power cords.

Step 3 Press down on both side latches and pull the device out of the rack enclosure until both slide rails lock.

Note You can reach the cables on the back of the device when the device is in the locked position.

Step 4 Lift the cover-release latch (see Figure 15). Lift the cover off the device and set the cover aside.

Figure 15 Removing the Cover

Cover-release latch

185089

Installing the Cisco WAE Inline Network Adapter

22

OL-12480-03

 

 

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Contents Product Overview Inline Network Adapter DescriptionPorts and LED Indicators LEDs State DescriptionAdapter Specifications Specification DescriptionSafety Guidelines General Precautions Important Operational Notes Protecting Against Electrostatic DischargeRemoving the Cover StatementInstalling an Inline Network Adapter Expansion slot cover slot Captive screw Riser card assembly Installing an Adapter in the Riser Card Assembly Completing the Installation Install the appliance in the rackInstalling Adapters in the WAE-512 and WAE-612 Appliances StatementInstalling an Inline Network Adapter Front Installing the Adapter in the Riser Card Assembly Installing Adapters in the WAE-7326 Appliance To remove the device top cover, follow these steps PCI-X Riser Card Riser card cage Scsi cable Completing the Installation Cover-release latch Removing the PCI-X Riser-Card Assembly Inverted riser assembly Access holes Guide Release tabs Cabling Connection Required Cable Cable Requirements for WAE Connections Using Fast Ethernet Router a Cabling Between Two Inline WAEs Related Documentation OL-12480-03
Top Page Image Contents