Introduction
Introduction
This document describes system requirements, important notes, new and changed information, installation and upgrade procedures, and caveats for CB21AG and PI21AG client adapter Install Wizard release 2.5 and the following software included in the Install Wizard file:
•CB21AG and PI21AG client adapter driver release 2.5
•Aironet Desktop Utility (ADU) release 2.5
System Requirements
You need the following items in order to install Install Wizard 2.5 and use its software components:
•One of the following Cisco Aironet client adapters:
–CB21AG
–PI21AG PCI card
•A computer running the Windows 2000 or XP operating system
Note Cisco recommends a
•Service Pack 2 for Windows XP
•20 MB of free hard disk space (minimum)
•128 MB of RAM or greater (recommended)
•If your wireless network uses
•If your wireless network uses PEAP
–A hardware token device from OTP vendors or the Secure Computing SofToken program (version 2.1 or later)
–Your hardware or software token password
•The Microsoft 802.1X supplicant, if your client adapter is installed on a Windows 2000 device and uses PEAP
•All necessary infrastructure devices (such as access points, servers, gateways, user databases, etc.) must be properly configured for any authentication type you plan to enable on the client.
•The following information from your system administrator:
–The logical name for your workstation (also referred to as client name)
–The protocols necessary to bind to the client adapter, such as TCP/IP
–The
–If your network setup does not include a DHCP server, the IP address, subnet mask, and default gateway address of your computer
Release Notes for Cisco Aironet 802.11a/b/g Client Adapters (CB21AG and PI21AG) Install Wizard 2.5
2 |
| |
|