Installing or Upgrading Client Adapter Software
Figure 10 Setup Status Window
The installation process begins, and you are notified as each software component is installed.
Step 26 When a message appears indicating that your computer needs to be rebooted, click OK and allow your computer to restart.
Step 27 If the Windows Found New Hardware Wizard appears after your computer reboots, click Next, allow the wizard to install the software for the client adapter, and click Finish.
Step 28 If your network setup does not include a DHCP server and you plan to use TCP/IP, follow these steps for your operating system.
•Windows 2000
a.
b.
c.Click Properties.
d.In the Components Checked Are Used by This Connection field, click Internet Protocol (TCP/IP) and Properties.
e.Choose Use the following IP address and enter the IP address, subnet mask, and default gateway address of your computer (which can be obtained from your system administrator).
f.Click OK to close each open window.
Release Notes for Cisco Aironet 802.11a/b/g Client Adapters (CB21AG and PI21AG) Install Wizard 2.5
18 |
| |
|