Fujitsu Siemens Computers S7210, S7211 Security Menu Setting the Security Features, Boot Exit

L i f e B o o k S S e r i e s B I O S

SECURITY MENU – SETTING THE SECURITY FEATURES

The Security menu allows you to set up the data security features of your notebook to fit your operating needs and to view the current data security configuration. (See Navigating through the Setup Utility on page 2 for more information.)

The following tables show the names of the menu fields for the Security Menu and its submenus, all the options for each field, the default settings and a description of the field's function and any special information needed to help understand the field's use. The default condition is no passwords required and no write protection.

Remember your passwords! If you set and forget your User and Master hard disk passwords, Fujitsu Computer Systems will not be able to reset it. You may lose data and have to replace your system board or hard disk drive.

■Entering a password incorrectly 3 times in a row causes the keyboard and mouse to be locked out and the warning [System Disabled] to be displayed. If this hap- pens, restart the computer by turning off and on the power with the power switch and use the correct password on reboot.

■If you make an error when re-entering the password a Warning will display on the screen. To try again press [Enter], then retype the password. Press [Esc] to abort the password setting process.

■If the Power Management Security is Enabled and the Password on Boot is Dis- abled you will not have to type your password upon resuming the system from the Suspend or Save-to-Disk modes. Power Management Security will work only if Password boot is enabled.

■Boot sector protection must be set to [Normal] to install or upgrade an operating system.

		Phoenix TrustedCore(tm) Setup Utility
Info	System	Advanced	Security			Boot	Exit
Supervisor Password Is:			Clear				Item Specific Help
User Password Is:			Clear
							Press <Enter> key to
Set Supervisor Password			[	Enter	]		set Supervisor Password
Set User Password			[Enter]				to enable any password
Minimum User Password Length:			[0]				features.
Password on Boot:			[Disabled]
On Automatic Wake up:			[Disabled]				Then password entry is
Boot from Removable Media:			[All]				required to enter BIOS
Flash Write:			[Enabled]				Setup.
▲ Hard Disk Security
▲ Owner Information
▲ TPM (Security Chip) Setting
Security Panel on Resume:			[Enabled]

F1	Help	Select	Item
ESC	Exit	Select	Menu

-/SpaceChange Values

Enter Select▲ Sub-Menu

F9 Setup Defaults

F10 Save and Exit

Figure 14. Security Menu

22