Inserting a PCI Card, Changing the Bracket

Chapter 1 Product Overview and Installation

Inserting the Client Adapter

Step 4 If the Found New Hardware Wizard window appears, click Cancel.

Note If you do not click Cancel, the wizard will attempt to install software for the client adapter but will be unable to find it.

Step 5 Go to the “Installing the Client Adapter Driver and Software” section on page 1-18.

Inserting a PCI Card

You must perform the following procedures in the order listed below to insert a PCI card:

•If required, change the bracket (see the “Changing the Bracket” section on page 1-11).

•Insert the card (see the “Inserting the Card” section on page 1-12).

•Assemble the antenna (see the “Assembling the Antenna” section on page 1-13).

•Mount the antenna (see the “Mounting the Antenna” section on page 1-14).

Changing the Bracket

The PCI card is shipped with a full-profile bracket attached. If the PC into which you are inserting the PCI card requires the card to use a low-profile bracket, follow these steps to change brackets.

Step 1 Remove the two screws that attach the bracket to the card. See Figure 1-4.

Figure 1-4 Changing the PCI Card Bracket

ACTIVITY

STATUS

95581

Bracket screws

Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide for Windows Vista

	OL-16534-01	1-11