Cisco Systems manual Cisco 10005 ESR DC Power Entry Module Installation, Contents

Page 1

Cisco 10005 ESR DC Power Entry

Module Installation

March 30, 2001

This installation note provides procedures for installing and replacing DC power entry modules (PEMs) in a Cisco 10005 edge services router (ESR).

Contents

The following sections are included in this installation note:

•Product Description, page 2

•Prerequisites and Preparation, page 2

•Adding or Replacing a DC PEM, page 8

•FCC Class B Compliance, page 20

•Related Documentation, page 21

•Obtaining Documentation, page 22

•Obtaining Technical Assistance, page 23

Corporate Headquarters: Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA

Copyright © 2001. Cisco Systems, Inc. All rights reserved.

78-12653-01

Image 1

Contents Contents Cisco 10005 ESR DC Power Entry Module InstallationPrerequisites and Preparation Product DescriptionSafety Warnings Safety GuidelinesPrerequisites and Preparation Prerequisites and Preparation Prerequisites and Preparation Quantity Description Comments Required Tools and EquipmentAdding or Replacing a DC PEM Installing a Second DC PEMInserting a DC PEM Replacing a DC PEMCisco 10005 ESR DC Power Entry Module Installation Removing and Replacing a DC PEM Preparing to Connect Power and Ground Wiring a DC PEMConnecting DC Ground Positioning the Power and Ground Terminals to Accept Wires Pull on the wire to ensure that it is held firmly in place Connecting DC Power Connecting Power to the Terminal Block Checking the DC Power Connection Symptom Steps to Take Troubleshooting the InstallationFCC Class B Compliance Manuals for All Cisco 10000 Series Routers Related DocumentationWorld Wide Web Obtaining DocumentationDocumentation CD-ROM Ordering DocumentationDocumentation Feedback Obtaining Technical AssistanceCisco.com Contacting TAC by Using the Cisco TAC WebsiteTechnical Assistance Center Contacting TAC by Telephone Obtaining Technical Assistance