Cisco Systems 806 manual Connecting the Power Supply

Page 31

Chapter 2 Installation

Installing Your Router

Figure 2-6 Connecting a Terminal or PC

TO HUB	ETHERNET	10BASET
TO PC		10BASET	COMPUTERS (E0)
			COMPUTERS (E0)
	4	3
		3	2
			2
			1

Model
CONSOLE	Cisco 806

ETHERNET
10BASET	+5 VDC
INTERNET (E1)

1.Connect RJ-45 connector on light blue cable to CONSOLE port.

2. Connect DB-9 connector to terminal or PC.

51821

Connecting the Power Supply

To connect the power supply, follow the steps in Figure 2-7.

Warning The device is designed to work with TN power systems.

Warning This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that a fuse or circuit breaker no larger than 120 VAC, 15A U.S. (240 VAC, 16A international) is used on the phase conductors (all current-carrying conductors).

Warning This equipment is designed to be grounded. Ensure that the host is connected to earth ground during normal use.

		Cisco 806 Router Hardware Installation Guide
		Cisco 806 Router Hardware Installation Guide
	78-10432-01			2-11
	78-10432-01			2-11

Image 31

Contents Cisco 806 Router Hardware Installation Guide Page Cisco 806 Router Hardware Installation Guide Page Product Overview FeaturesLEDs Installation Vii Viii Organization AudienceConventions Preface Conventions Obtaining Documentation Related DocumentationWorld Wide Web Ordering Documentation Documentation CD-ROMDocumentation Feedback Cisco.com Obtaining Technical AssistanceTechnical Assistance Center Contacting TAC by Using the Cisco TAC WebsiteXvi Feature Description FeaturesFront Panel Router OverviewCable lock Ethernet ports Back PanelColor Function LEDsSafety Preparing for InstallationBefore installing the router, read the following warnings Preventing Electrostatic Discharge Damage Items Included with Router Unpacking the BoxPreventing Router Damage Installing Your RouterNetwork Device Router Button Ethernet Cable Connecting Ethernet DevicesConnecting a Hub Connecting a Server, PC, or Workstation Connecting a Broadband Modem Connecting to the InternetConnecting an Ethernet Switch Connecting a Terminal or PC to the Console PortTo connect the power supply, follow the steps in Figure Connecting the Power SupplyPower/Link LEDs to Check Normal Patterns Verifying Your Router InstallationMounting on Table Mounting Your RouterWall-Mounting Brackets Bottom of Router Mounting on WallInstallation Mounting Your Router Mounting Router On Wall Http//10.10.10.1 Where to Go from HereCisco 806 Router Hardware Installation Guide Before You Call Your Cisco Reseller TroubleshootingSymptom Problem Solutions Problems During Initial StartupComputer Problems After Router Is RunningTroubleshooting Problems After Router Is Running Description Design Specification Physical Dimensions System SpecificationsEnvironmental Operating Ranges Description Design Specification Router Power Port Connector PinoutsNational laws and regulations Pin Function Function To HUB/TO PC Button Pin Position OUT PositionEthernet Cable Specifications Cabling SpecificationsType Category Shielding Maximum Cable DistancesCable Maximum Distance Appendix a Specifications and Cables Cabling Specifications Numerics GL-2 GL-3 GL-4 D E IN-2 IN-3 IN-4 Router Wall-Mount Template