Cisco Systems ASR 1000 manual Configuration Example Output

Chapter 7 H.248 Services—Signaling and Control

ServiceChange Notification for Interface Status Change

DETAILED STEPS

	Command or Action	Purpose
Step 1
	enable	Enables privileged EXEC mode.
		• Enter your password if prompted.
	Example:
	Router> enable
Step 2
	configure terminal	Enters global configuration mode.
	Example:
	Router# configure terminal
Step 3
	interface type number	Configures an interface type and enters into interface
		configuration mode.
	Example:
	Router(config)# interface port-channel 99
Step 4
	sbc interface-id {value}	Maps the physical-interface-id contained in the termination
		ID for the pinhole to the port channel interface.
	Example:
	Router(config-if)# sbc interface-id 2
Step 5
	end	Exits interface configuration mode and returns to privileged
		EXEC mode.
	Example:
	Router(config-if)# end

Configuration Example Output

In the following configuration output example, the sbc interface-idcommand maps physical-interface-id 1 contained in the termination ID for the pinhole to GigabitEthernet interface 1:

interface gigabitethernet1

sbc interface-id 1 no ip address negotiation auto no keepalive

no cdp enable end

Subsequently, when GigabitEthernet interface 1 changes status, a service change with a wildcarded termination ID is reported to the SBE, where 1 is the physical-interface-id in tier-5 of the nine-tier termination ID and the SBE is able to associate status changes on GigabitEthernet interface 1 with a pinhole:

*/*/*/*/1/*/*/*/*

Cisco IOS XE Integrated Session Border Controller Configuration Guide for the Cisco ASR 1000 Series Aggregation Services Routers

OL-15421-01 7-13