Chapter 10 Cisco WAN Manager Operations
Downloading Software and Firmware
Replace the <IP_addr_CWM_workstation> parameter with the IP address of the CWM machine that initiates a firmware or software download.
Note This is required if you are using a CWM workstation to send the download request to the switch.
The following example is shown for a Cisco BPX node:
This Command: cnffwswinit
Enter FW/SW Initiator SV+ IP addr(192.0.0.0):
Related Topics
•“Managing with the Configuration Save and Restore Utility” section on page
•“Downloading Software and Firmware” section on page
•“Monitoring a Download Session on Cisco BPX and Cisco IGX Nodes” section on page
•“Downloading Switch Software or Firmware from the CWM Workstation to a Switch” section on page
•“Cisco IGX and Cisco BPX Conventions” section on page
•“Cisco MGX Conventions” section on page
•“Managing with the Image Download” section on page
•“Deleting Images” section on page
Monitoring a Download Session on Cisco BPX and Cisco IGX Nodes
The dsprevs (software) command and dspfwrev (firmware) command display existing software (or firmware) revisions on a routing network, as well as the revisions currently being downloaded. When these commands are issued at a feeder, revisions on that feeder alone appear on the screen.
You can use the dsprevs command or dspfwrev command to see when downloading of the software or firmware is complete.
Related Topics
•“Managing with the Configuration Save and Restore Utility” section on page
•“Downloading Software and Firmware” section on page
•“Preparing the Cisco BPX and Cisco IGX Switch to Download Software or Firmware” section on page
•“Downloading Switch Software or Firmware from the CWM Workstation to a Switch” section on page
•“Cisco IGX and Cisco BPX Conventions” section on page
•“Cisco MGX Conventions” section on page
•“Managing with the Image Download” section on page
•“Deleting Images” section on page
|
| Cisco WAN Manager User’s Guide |
|
| |
|
|
| |||
| Release 15, Part Number |
|
|
|
|
|
|
|
| ||