Chapter 10 Cisco WAN Manager Operations
Saving and Restoring Configurations
The following example shows that the Configuration Save/Restore function is enabled on the Cisco BPX node:
node TN | Cisco | BPX 8620 9.4.00 | Feb. 14 2003 16:36 GMT | |
Index | Status | Function |
| |
1 | Enabled | Configuration Save/Restore |
| |
2 | Enabled | ForeSight |
| |
3Disabled Multiple VTs (1 session enabled)
4Disabled Virtual Trunks
5 | Enabled | ABR standard with VSVD |
6Disabled Priority Bumping
7Disabled Virtual Ports
This Command: cnfswfunc 1 e
The output of cnfswfunc command is different on an Cisco IGX 8400 series switch. The following example shows that the Configuration Save/Restore function is enabled on the Cisco IPX node:
node TN | Cisco | IGX 8430 9.4.00 | Feb. 14 2003 17:27 GMT | |
Index | Status | Function |
| |
1 | Disabled | Repetitive Pattern Suppression |
| |
3 | Enabled | Frame Relay |
| |
4 | Enabled | Configuration Save/Restore |
| |
5Disabled ForeSight
6Disabled Frame Relay
7Disabled Multiple VTs (1 session enabled)
8Disabled Interface Shelf
9Enabled Virtual Trunks
10Disabled ABR standard with VSVD
This Command: cnfswfunc 4 e
Next Command:
Step 6 Enter the dspcnf command to check whether a firmware image is loaded on the node. When a a firmware image is loaded on the node, the following message appears in the status column from the dspcnf command:
Reserved for firmware image
The following example is displays the results from the dspcnf command:
bpx1 | TN | Cisco | BPX 8620 | 9.3.h1 | Mar. 9 2001 15:16 GMT |
Node | Backup ID | Revision | Date/Time (GMT) | Status |
|
bpx1 | cisco111 | 9.3.h1 | 03/08/01 23:32:16 | Save on 172.29.10.72 complete | |
sw200 |
|
|
| Reserved for firmware image | |
sw76 | cisco111 | 9.3.j3 | 03/08/01 23:32:16 | Save on 172.29.10.72 complete | |
magneto | cisco111 | 9.3.h1 | 03/08/01 23:32:16 | Save on 172.29.10.72 complete | |
Last Command: dspcnf
Next Command:
Step 7 Enter the savecnf command to use the same buffers that are used by a loaded firmware image. Therefore, when a firmware image is loaded on the node, the savecnf command displays an error.
|
| Cisco WAN Manager User’s Guide |
|
| |
|
|
| |||
| Release 15, Part Number |
|
|
|
|
|
|
|
| ||