Cisco Systems Network Router manual Xxiv

Page 24

About This Guide

Documentation

Table 3 Descriptions of Technical Manuals and Release Notes for Cisco Multiservice Switch Products (continued)

Document Title

Description

 

 

Cisco MGX 8800 Series Switch Command Reference, Release

Provides detailed information on the general command line

1.1.3

for the Cisco MGX 8850 (PXM1), Cisco MGX 8250, and

DOC-7811210=

Cisco MGX 8230 edge concentrators.

 

 

 

Cisco MGX 8800 Series Switch System Error Messages,

Provides error message descriptions and recovery procedures

Release 1.1.3

for Cisco MGX 8850 (PXM1), Cisco MGX 8250, and

DOC-7811240=

Cisco MGX 8230 edge concentrators.

 

 

 

Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco

Describes how to install the Cisco MGX 8950, the

MGX 8830, and Cisco MGX 8880 Hardware Installation

Cisco MGX 8850 (PXM1E/PXM45), and the

Guide, Releases 2 Through 5

Cisco MGX 8830 switches. Also describes how to install the

OL-4545-01

MGX 8880 Media Gateway. This document explains what

each switch does and covers site preparation, grounding,

 

 

safety, card installation, and cabling. The Cisco MGX 8850

 

switch uses either a PXM45 or a PXM1E controller card and

 

provides support for both serial bus-based and cell bus-based

 

service modules. The Cisco MGX 8830 switch uses a

 

PXM1E controller card and supports cell bus-based service

 

modules. The Cisco MGX 8950 supports only serial

 

bus-based service modules. The Cisco MGX 8880 uses a

 

PXM45/C controller card, and supports only serial bus-based

 

service modules. This hardware installation guide replaces

 

all previous hardware guides for these switches.

 

 

Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco

Describes how to configure the Cisco MGX 8880 Media

MGX 8830, and Cisco MGX 8880 Configuration Guide,

Gateway. Also describes how to configure Cisco MGX 8850

Release 5

(PXM1E), Cisco MGX 8850 (PXM45), and Cisco

OL-4546-01

MGX 8830 switches to operate as ATM edge switches and

the Cisco MGX 8950 switch to operate as a core switch. This

 

 

guide also provides some operation and maintenance

 

procedures.

 

 

Cisco MGX 8850 (PXM45/PXM1E), Cisco MGX 8950, Cisco

Describes the PXM commands that are available in the CLI

MGX 8830, and Cisco MGX 8880 Command Reference,

of the Cisco MGX 8850 (PXM45), Cisco MGX 8850

Release 5

(PXM1E), Cisco MGX 8950, and Cisco MGX 8830 switches.

OL-4547-01

Also describes the PXM commands that are available in the

CLI of the Cisco MGX 8880 Media Gateway.

 

 

 

Cisco MGX 8850 Edge Concentrator Installation and

Provides installation instructions for the Cisco MGX 8850

Configuration, Release 1.1.3

(PXM1) edge concentrator.

DOC-7811223=

 

 

 

Cisco MGX 8850 Multiservice Switch Overview, Release 1.1.3

Describes the system components and function of the

OL-1154-01

Cisco MGX 8850 (PXM1) edge concentrator.

 

 

 

Cisco MGX and Service Expansion Shelf Error Messages,

Provides error message descriptions and recovery

Release 5

procedures.

OL-4553-01

 

 

 

 

Cisco PNNI Network Planning Guide for MGX and SES Products, Release 5

xxiv

Part Number OL-3847-01 Rev. D0, April, 2004

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Corporate Headquarters Text Part Number OL-3847-01 Rev. D0Copyright 2003, Cisco Systems, Inc All rights reserved N T E N T S IiiCompatible Standards Worksheets Part Number OL-3847-01 Rev. D0, April G U R E S ViiViii B L E S Part Number OL-3847-01 Rev. D0, April Objectives AudienceOrganization Conventions XiiDocumentation Documentation Notes for the April 2004 Product ReleasesRelated Documentation XiiiTechnical Manual Order of Use XivTechnical Manual Titles and Descriptions TermsXvi Xvii Xviii Xix Reference Guides Xxi Document Title Description XxiiXxiii Xxiv Xxv Xxvi Obtaining Documentation Cisco.comOrdering Documentation XxviiChanges to This Document Chapter ChangesXxviii Obtaining Technical Assistance Documentation FeedbackCisco TAC Website Opening a TAC CaseObtaining Additional Publications and Information TAC Case Priority DefinitionsXxx Xxxi Xxxii Introduction to Pnni Pnni Network DatabaseSingle Peer Group Topology Hierarchical Pnni Network Topology Example Single Peer Group TopologyPeer group Ppeer Peer Group Leaders Simple Node RepresentationComplex Node Representation Simple Node RepresentationPnni Internetworking with Aini Border NodesHierarchical Pnni Network Benefits Pnni Internetworking with Iisp Example Pnni Internetworking with Aini TopologyPart Number OL-3847-01 Rev. D0, April Specifications Compatible StandardsPXM45 CapabilitiesPXM1E PXM45/BCapabilities SES SESConnection Limit Adjustments Connection Type Switch Connections CWM EndpointsSVC DAX SpvcInstall Redundant Hardware in Switches Parallel Links Between Adjacent SwitchesPhysical Network Planning Planning Guidelines for Individual Peer Groups Multiple Links Between Adjacent Peer GroupsMultiple Links to an External Network Multiple Paths Between Network NodesPlanning Guidelines for Hierarchical Networks Planning Guidelines for Peer Group LeadersPlanning Guidelines for Border Nodes Part Number OL-3847-01 Rev. D0, April Address and Closed User Group Planning Address Planning OverviewPnni Addressing Example Planning Address Configuration Settings Selecting an ATM Address FormatSupported Address Formats ESI SEL IDP DSPATM Field Description Default Values Guidelines for Selecting an Address FormatSelecting a Pnni Level Address Registration AuthoritiesCategory Type Authorities DCC4shows an example topology of a Pnni MPG WAN Part Number OL-3847-01 Rev. D0, April Length Level Peer Group ID Portion of ATM Address BytesDefault Peer Group ID Selecting the Pnni Peer Group IDSelecting the ATM Address 20-byte Node AddressSelecting the Ilmi Address Prefix Selecting the Spvc Address PrefixPlanning Address Prefixes for Aini and Iisp Links Selecting Static Addresses for UNI Ports Additional Guidelines for Creating an Address PlanClosed User Group Overview Closed User Group ExamplePlanning CUG Configuration Settings Selecting an Interlock CodeSelecting an Index Selecting Internal CUG Access Options Selecting CPE AddressesSelecting External CUG Access Options Specifying a Preferential CUGSelecting a Default CUG Address WorksheetsCUG Part Number OL-3847-01 Rev. D0, April Administrative Weight How MGX and SES Nodes Select RoutesLink and Route Metrics Cell Transfer Delay Cell Delay VariationAvailable Cell Rate Shortest Path Table Routing Maximum Cell RateShortest Path Tables Class of Service Tables Service Class Acronym Definition GuidelinesCTD CDV Traffic MetricHow SVCs and SVPs use the SPTs How SPVCs and SPVPs use the SPTsHow MGX and SES Nodes Select Links On-Demand RoutingLoad Balancing for SPT and On-Demand Routing Additional Routing Features in MGX and SES Nodes ServicePreferred Routing CLR0+12Priority Routing GroomingSoft Rerouting Priority BumpingBlocking Pass-Through Connections Nodal Point-to-Multipoint Branch RestrictionAXSM/A AXSM/BAXSM-E AXSM-XGFarthest Node Branching Part Number OL-3847-01 Rev. D0, April ABR AesaAini Ansi APSP2MP CBRCTD IN-2CUG CWMDIN IN-3IN-4 PGL PnniMGX SES IN-5IN-6 UBR UNITAC IN-7IN-8
Top Page Image Contents