Cisco Systems uBR7246VXR quick start Installing the Cable-Management Brackets

Figure 7 Installing the Rack-Mount Brackets in the Middle of the Chassis for Open or Relay-Type Racks

	Rack-mount
Rack-mount bracket	bracket

103561

Installing the Cable-Management Brackets

If you are rack-mounting the chassis at the rear or middle of the chassis, both rack-mount brackets and the cable-management bracket must be installed before the chassis is installed in the rack. See Figure 8 for cable management bracket locations.

To install the cable-management bracket, complete the following steps:

Step 1 Align the cable-management bracket with the four right front threaded holes in the chassis.

Step 2 Thread four M4 x 6-mm Phillips flathead screws through the bracket and into the chassis, and use a number 2 Phillips screwdriver to tighten the screws.

Figure 8 Location of Cable Management Bracket

1

2

Cable-management

Rack-mount bracket bracket

Cable management bracket

Rack-mount bracket

103571

1

Location of cable management bracket—rear mount

2

Location of cable management bracket—middle mount

11