Cisco Systems OL-9977-05 manual For Home or Office USE

Page 64

Appendix B Declarations of Conformity and Regulatory Information

Manufacturers Federal Communication Commission Declaration of Conformity Statement

Manufacturers Federal Communication Commission Declaration of Conformity Statement

Tested To Comply

With FCC Standards

FOR HOME OR OFFICE USE

Model:

AIR-LAP1510AG-A-K9

AIR-LAP1505G-A-K9

FCC Certification number:

LDK102058

Manufacturer:

Cisco Systems, Inc.

170 West Tasman Drive

San Jose, CA 95134-1706

USA

This device complies with Part 15 rules. Operation is subject to the following two conditions:

1.This device may not cause harmful interference, and

2.This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment. This equipment generates, uses, and radiates radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference. However, there is no guarantee that interference will not occur. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one of the following measures:

•Reorient or relocate the receiving antenna.

•Increase separation between the equipment and receiver.

•Connect the equipment to an outlet on a circuit different from which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician.

Caution The Part 15 radio device operates on a non-interference basis with other devices operating at this frequency when using Cisco-supplied antennas. Any changes or modification to the product not expressly approved by Cisco could void the user’s authority to operate this device.

Cisco Aironet 1500 Series Outdoor Mesh Access Point Hardware Installation Guide

 

B-2

OL-9977-05

 

 

 

Page 63 Page 65
Image 64
Page 63 Page 65
Contents Americas Headquarters Page N T E N T S Mesh Network English Translation B-5 OL-9977-05 Preface ObjectivesAudience OrganizationConventions Bewaar Deze InstructiesSäilytä Nämä Ohjeet Guarde Estas Instruções GEM Disse Anvisninger Viii Related Publications Obtaining DocumentationDocumentation Feedback Cisco Product Security OverviewCisco.com Product Documentation DVD Ordering DocumentationReporting Security Problems in Cisco Products Product Alerts and Field NoticesObtaining Technical Assistance Cisco Support WebsiteSubmitting a Service Request Finding the Product Serial NumberDefinitions of Service Request Severity Obtaining Additional Publications and InformationPreface Obtaining Additional Publications and Information Xvi Hardware Features, Network Configuration Examples, OverviewHardware Features Access Point ConnectorsSingle or Dual Radio Operation ConnectorsExternal Antennas Multiple Power Sources Part Number Model Gain dBiEthernet Port Metal Enclosure Network Configuration ExamplesOptional Hardware Wireless Backhaul Point-to-Point BridgingPoint-to-Multipoint Bridging Mesh NetworkTypical Mesh Configuration Using Access Points Typical Layer 3 Access Point Network Configuration Example Layer 2 and Layer 3 Network OperationTypical Layer 2 Access Point Network Configuration Example OL-9977-05 Mounting Instructions Package Contents Unpacking the Access PointTools and Materials Safety Information FCC Safety Compliance Statement Safety PrecautionsAvoiding Damage to Radios in a Testing Environment Installation Guidelines Site SurveysBefore Beginning the Installation Becoming Familiar with Access Point Installation ComponentsComponents in a Typical Access Point Installation Streetlight Power Tap Adapter Installation Enabling Zero Touch Configuration on the Controller Choose Security MAC Filtering NewConfiguring a RAP Mounting the Access PointInstallation Options Access Point Mounting Orientations Preferred Horizontal Orientation 5illustrates the access point vertical orientation Access Point Mounting Plate and Carriage Bolts Roof-Overhang Installation Mounting Plate Screw Hole LocationsMounting the Access Point on a Pole Adjustment Plate Attached to the Mounting Plate Pole Clamp and Clamp Adjustment Plate Mounted on a Pole 10 Access Point Attached to the Pole Clamp Grounding the Access Point Streetlight Pole InstallationsS c o C o n f i d e n t i a l D r a ft 11 Using the Streetlight Power Tap Adapter What to Do Next Troubleshooting Guidelines for Using the Access Points Controller MAC Filter ListMisconfigured Bridge Shared Secret Key Using Dhcp OptionMisconfigured Mesh Access Point IP address Access Point Power Verifying Controller AssociationTranslated Safety Warnings OL-9977-05 Declarations of Conformity Regulatory Information For Home or Office USE Vcci Statement for Japan Industry Canada Canadian Compliance StatementDeclaration of Conformity for RF Exposure Chinese TranslationEnglish Translation Operation of Cisco Aironet Access Points in Brazil Access Point ModelsAccess Point Specifications CCKANSI/IEEE C62.41 Channels and Power Levels OL-9977-05 Connector Pinouts Pin Number Signal NameVDC power + Priming Access Points Prior to Deployment Figure F-1 Typical Priming ConfigurationAppendix F Priming Access Points Prior to Deployment Appendix F Priming Access Points Prior to Deployment OL-9977-05 Configuring Dhcp Option Access Point Vendor Class Identifier VCI OverviewConfiguring Option 43 for 1000 Series Access Points Quotation marks must be includedType + Length + Value Configuring Option 43 for 1500 Series Access Points OL-9977-05 D E IN-2 IN-3 IN-4

OL-9977-05 specifications

Cisco Systems OL-9977-05 is a pivotal reference guide that caters to networking professionals seeking an in-depth understanding of Cisco's infrastructure and certification processes. It encapsulates the essence of modern networking technologies, emphasizing the importance of robust, scalable, and secure network architectures.

One of the primary features of the OL-9977-05 document is its comprehensive overview of Cisco's routing and switching technologies. It covers essential protocols such as OSPF, EIGRP, and BGP, explaining how these dynamic routing protocols contribute to efficient data transmission across diverse networks. Cisco’s focus on interoperability ensures that various systems can communicate smoothly, a critical characteristic in today’s multi-vendor environments.

Security is a cornerstone of Cisco's offerings, and OL-9977-05 delves into advanced security frameworks, including the implementation of firewalls, intrusion prevention systems, and VPNs. It emphasizes the significance of securing both physical and virtual network components to thwart cyber threats. The documentation highlights Cisco's security technologies, such as Cisco Umbrella and Cisco SecureX, providing insights into creating a resilient and secure network.

Another salient feature of the OL-9977-05 is its focus on emerging technologies like software-defined networking (SDN) and network function virtualization (NFV). These technologies represent a paradigm shift in how networks are designed and managed, allowing for more flexible, efficient, and programmable network resources. The guide explores Cisco's innovations in these areas, such as the Cisco ACI and Cisco DevNet, which facilitate the automation and orchestration of network services.

Collaboration and communication tools are also well-covered within the document, highlighting Cisco’s Unified Communications solutions. These tools enhance productivity by enabling seamless communication across various platforms and devices. The integration of cloud services further extends the capabilities of these solutions, aligning with modern business needs.

In conclusion, Cisco Systems OL-9977-05 serves as an essential resource for networking professionals. Its focus on advanced routing and switching, robust security protocols, cutting-edge technologies like SDN and NFV, and collaboration tools provides a holistic view of Cisco's network solutions. This documentation not only supports Cisco certification preparation but also serves as a valuable reference for real-world networking scenarios, ensuring that professionals are well-equipped to tackle the challenges of contemporary network management.
Top Page Image Contents