Chapter 4 Zone Configuration
Basic Zone Configuration
2.Choose ENTER. The following prompt appears:
To duplicate a zone from the zone command group level perform the following:
1.From the Zone command group level of the desired zone type the following:
Where
2.Choose ENTER. Below is an example of the zone command implementation:
Removing a Zone
The user may remove a desired zone.
Caution Removing a zone eliminates its DDoS detection.
To remove a desired zone perform the following:
1.From the Configuration command group level type the following:
Where
2.Choose ENTER.
Note The Detector allows inserting an asterisk (*) as a wildcard character at the end of a zone name. Thus, a user may use the wildcard character (*) to remove several zones with the same prefix in one command.
| Cisco Traffic Anomaly Detector User Guide |