Cisco Systems OL-6109-01 manual Ending the Zone Detection

Chapter 4 Zone Configuration

Zone Detection

The sample screen indicates that zone traffic is mirrored (or split), the Detector receives the zone’s traffic and the traffic shows normal flow fluctuations. Zone detection is functioning properly.

Ending the Zone Detection

The user may wish to end the zone detection.

To end a zone’s protection, from the Global command group level type the following:

admin@DETECTOR# no detect <zone-name>

Or alternatively:

From the Zone command group level type the following:

admin@DETECTOR-conf-zone-<zone-name># no detect

Where zone-namespecifies a zone name.

Note that the Detector enables the use of an asterisk (*) as a wildcard denoting either of the following options:

•All of the Detector’s zones. Issuing no detect * means ending detection for all of the Detector’s zones.

•A wildcard denoting zone names (i.e. OBL*).

To know more about the Detector filter system, filter types, and filter configuration refer to Chapter 6, “Filter Procedures” for further details.

	Cisco Traffic Anomaly Detector User Guide
4-22	OL-6109-01