Cisco Systems 1260 specifications

Page 11

c.If the access point shuts down, check the power source.

d.After the access point finds the Cisco wireless LAN controller, it attempts to download the new operating system code if the access point code version differs from the Cisco wireless LAN controller code version. While this is happening, the Status LED blinks dark blue.

e.If the operating system download is successful, the access point reboots.

Step 3 Configure the access point if required. Use the controller CLI, controller GUI, or Cisco WCS to customize the access-point-specific 802.11n network settings.

Step 4 If the pre-installation configuration is successful, the Status LED is green indicating normal operation. Disconnect the access point and mount it at the location at which you intend to deploy it on the wireless network.

Step 5 If your access point does not indicate normal operation, turn it off and repeat the pre-installation configuration.

Note When you are installing a Layer 3 access point on a different subnet than the Cisco wireless LAN controller, be sure that a DHCP server is reachable from the subnet on which you will be installing the access point, and that the subnet has a route back to the Cisco wireless LAN controller. Also be sure that the route back to the Cisco wireless LAN controller has destination UDP ports 5246 and 5247 open for CAPWAP communications. Ensure that the route back to the primary, secondary, and tertiary wireless LAN controller allows IP packet fragments. Finally, be sure that if address translation is used, that the access point and the Cisco wireless LAN controller have

astatic 1-to-1 NAT to an outside address. (Port Address Translation is not supported.)

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Cisco Aironet 1260 Series Lightweight Access Point About this Guide Safety Instructions20A. Statement Overview UnpackingAccess Point Ports and Connections, Bottom Controller Discovery Process Configuring the Access PointPreparing the Access Point Performing a Pre-Installation Configuration Installation SummaryController Layer 3 devices Cisco Aironet access points Pre-Installation Configuration SetupPage Page Configuring Security Settings Page Deploying the Access Point on the Wireless Network Mounting the Access PointUsing Dhcp Option TroubleshootingShows the location of the access point Status LED Checking the Access Point LEDLED Troubleshooting the Access Point Join Process Page Declarations of Conformity and Regulatory Information Vcci Statement for Japan 03-6434-6500 Industry Canada Statement 371-Power Cable and AC AdapterModels Page Page United States Declaration of Conformity for RF ExposureChinese Translation English Translation Operation of Cisco Aironet Access Points in Brazil Portuguese Translation Declaration of Conformity StatementsCisco AP c1260 Category Specification Access Point SpecificationsAccess Point Specifications
Top Page Image Contents