Cisco Systems PSUS4 manual Starting the Bi-Admin Management Utility, Main Option

Chapter 4

Bi-Admin Management

6.When the Bi-Admin is installed, the Setup Complete screen will appear. Click Finish to continue.

Setup Complete

Starting the Bi-Admin Management Utility

1.To start the Bi-Admin program, click Start, Programs, Print Server Utility, and then Bi-Admin Management Utility. If the Bi-Admin Management Utility icon has been created, you can double-click it instead. You can drag the shortcut icon onto your Desktop for easy access to the Bi-Admin Management Utility.

2.When the Bi-Admin Management Utility appears, make sure that TCP/IP is the Connected Protocol. Click OK.

Connected Protocol

3.The Bi-Admin Management Utility will automatically scan the network for the USB PrintServer.

Searching for device

The Bi-Admin Management Utility

The Bi-Admin Management Utility screen will appear next. Any hardware found on the network will appear on the left-hand side of the screen. The Utility can be managed from this screen.

Bi-Admin Management Utility

The Utility’s main menu contains the following options:

•• Main

•• InitDevice

•• Diagnostic

•• Help

These options and their submenus are described below.

Main Option

When you select Main from the menu bar, these options are displayed:

•• Device Status

•• Printer Status

•• Configuration

•• Upgrade

•• Refresh

•• Exit

These options also correspond to the icons that appear below the menu options (viewed from left to right).

Device Status  This option allows you to view all of the device settings, and optionally save the device settings to a file, or restore a previously saved file to the device.

If you click Device Status, the Device Information screen appears. A list of the PrintServer’s device settings is displayed that contains the Hardware ID, Firmware version, Protocol ID, Default Name, and Server Name. To save the information in a txt. file, click Save to file.

PrintServer for USB with 4-Port Switch 10