•• Internet Printing
Configuration > Internet Printing Tab
Enter the address of your mail server in the Mail Server IP Address field. (This value must be a fixed IP address.) Next enter the mail account name in the Mail Account field and the password in the Password field. Enter the password again in the Confirm Password field. Then, enter the time interval for the PrintServer to check for e-mail to be printed, in hours and minutes in the Check Mail Interval: field. You may also specify an e-mail address to which mails that cannot be printed are routed; this is useful for both graphic-intensive e-mails and for troubleshooting purposes. Enter this e-mail address in the Redirect Mail Account: field. Select the default printer port from the Default Printer Port drop- down menu. Enter the printer model in the Printer Model field (you can find this in the Device Manager). Place a check mark next to your preferences for options. Select any options that you want to enable: Print every Mail, Banner Printing (enabled by default), or Mail response when Printed.
Click Get Defaults if you want to return the settings to the default settings.
When you are finished making your changes on this tab, click OK to save these changes, or click Cancel to undo your changes. For more information, click Help.
•• Port
Configuration > Port Tab
Select the number of the Selected Physical Port from the drop-down menu. Select the Handshake Signal (Busy Only or Busy & Ack). Select the Printer Type (High Speed or Low Speed). Select the Selected Logical Port from the drop-down menu, then the physical port you want to map it to from the drop-down menu for Map to Physical Port. If you select Yes for Convert LF to LF+CR, the LF (line feed) characters are changed to LF+CR (line feed +carriage return). In the Prefix of Job field, enter the printer control string (in hexadecimal characters) to be sent to the printer before each print job. This string cannot exceed 30 characters. In the Suffix of Job field, enter the printer control string (in hexadecimal characters) to be sent to the printer after each print job. This string cannot exceed 30 characters.
Click Get Defaults if you want to return the settings to the default settings.
When you are finished making your changes on this tab, click OK to save these changes, or click Cancel to undo your changes. For more information, click Help.