Chapter 4 Replacement Procedures
Installing the LCD unit
The following describes the procedure for installing the LCD unit.
Install the LCD supports (LCD unit side) and hinge to the LCD and secure them with the following screws.
∙ M2×2.5F FLAT BIND screw | x4 |
1.Stand the LCD unit on the display cover and connect the LCD harness to the connector on the back of LCD.
2.Stick the MYLAR tape on the connector of LCD harness.
3.Secure the LCD unit with the following screws, and connect LCD harness with CCD FPC.
| ∙ | M2.0×3.0F | FLAT BIND screw | x4 |
4. | Secure the display mask with following screws |
| ||
| ∙ | M2.0×4.0F | FLAT BIND screw | x4 |
5. | Cover screws with Screw MYLAR cover x4 |
| ||
NOTE: When installing the display mask, make sure there is no gap between the display mask and the display cover.
|
|
|
Satellite T110 / Satellite Pro T110 / PORTEGE T110 Maintenance Manual | 50 | |
