Chapter 4 Replacement Procedures

4.12 System board

CAUTION: 1. when handling the system board, always hold by the edges. Do not touch the printed circuit face.

2.if replacing with a new system board, execute the subtest01 Initial configuration in section 3.3 “Setting of the hardware configuration”.

Removing the system board

The following describes the procedure for removing the system board (See Figure 4-12-1).

1.Disconnect the LAN BOARD FFC, LCD CABLE, Antenna cable, Audio board

FFC, HDMI FFC, Bluetooth cable, SIM CARD FFC, TP board FFC, Power Board FFC, HDD cable from the connector on the system board.

2.Remove the following screws securing the system board and remove the system board.

∙ M2.0×3.0F FLAT BIND screw x2

3. Disconnect the RGB cable and DC-IN cable from the connector on the system board.

Figure 4-12-1 Remove the system board

 

 

 

Satellite T110 / Satellite Pro T110 / PORTEGE T110 Maintenance Manual (960-Q08)

40

Page 188
Image 188
Toshiba T110, ProT1!0 manual System board, Removing the system board