Chapter 4 Replacement Procedures
Installing the display assembly
The following describes the procedure for installing the display assembly.
1.Inserting the pole of hinge to the hole of hinge assembly, set the display assembly with hands on the base assembly.
2.Secure the hinges with the following screws.
‧ M2.0 ×4F FLAT BIND screw | x4 |
Figure 4-8-10 Secure the hinge screws
NOTE: Be sure to apply the locktight to the screws instructed in the figure above.
3. Connect the LCD harness to the connector on the system board.
Satellite T110 / Satellite Pro T110 / PORTEGE T110Maintenance Manual | 28 |
