Cabletron Systems 9T101-04 manual Reset Switch, Local Management Console

Page 15

The Reset Switch

The Reset Switch

The Reset switch is located on the front panel, under the top plastic tab, as shown in Figure 2-2.It serves two functions:

•Pressing the Reset switch twice within three seconds causes the processor to reset.

•Pressing and holding the switch on for three or more seconds causes the module to shutdown. Pressing and holding again for three seconds restarts the module.

SNMP management may be used to disable this switch to enhance module security.

Reset Switch

Figure 2-2. The Reset Switch

Local Management Console

Local Management is accessed by attaching a management console at the RJ-45 CON port of the 9T101-04. The console connection supports a Digital Equipment Corporation VT 320™ terminal or PC emulation of one of these terminals.

Table 2-1lists the setup requirements for the local management console. If your terminal is a Digital Equipment Corporation VT 320™ terminal, press F3 to access the Setup Directory. If you have a terminal emulation of the Digital Equipment terminals, refer to your equipment user manual for setup procedures.

2-3

Page 14 Page 16
Image 15
Page 14 Page 16
Contents MMAC-Plus9T101-04 Four Port Token Ring Router User’s Guide Page Page Vcci Notice FCC NoticeDOC Notice Page Contents Contents Introduction FeaturesManagement Information Base MIB Support Features Getting Help Related ManualsInstalling the MMAC-Plus Module Installing the MMAC-Plus Module Local Management Console Reset SwitchMenu Function Selection Local Management Console Installing the MMAC-Plus Module Operation T101-04 Block DiagramDC/DC Converter System Diagnostic ControllerFlexible Network Bus FNB System Management BusesCPU FNB InterfaceOperation Lanview LEDs Lanview LEDsLED Color State Description Green Mbps Off Lanview LEDs Safety ServiceSpecifications Environment Physical
Top Page Image Contents