Cabletron Systems W85 manual Cabletron Systems Limited Program License Agreement

Page 8

Notice

component of a plant, export to Country Groups D:1 or E:2 the direct product of the plant or a major component thereof, if such foreign produced direct product is subject to national security controls as identified on the U.S. Commerce Control List or is subject to State Department controls under the U.S. Munitions List.

5.UNITED STATES GOVERNMENT RESTRICTED RIGHTS. The enclosed Product (i) was developed solely at private expense; (ii) contains “restricted computer software” submitted with restricted rights in accordance with section 52.227-19 (a) through (d) of the Commercial Computer Software-Restricted Rights Clause and its successors, and (iii) in all respects is proprietary data belonging to Cabletron and/or its suppliers. For Department of Defense units, the Product is considered commercial computer software in accordance with DFARS section 227.7202-3 and its successors, and use, duplication, or disclosure by the Government is subject to restrictions set forth herein.

6.EXCLUSION OF WARRANTY. Except as may be specifically provided by Cabletron in writing, Cabletron makes no warranty, expressed or implied, concerning the Program (including its documentation and media).

CABLETRON DISCLAIMS ALL WARRANTIES, OTHER THAN THOSE SUPPLIED TO YOU BY CABLETRON IN WRITING, EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, WITH RESPECT TO THE PROGRAM, THE ACCOMPANYING WRITTEN MATERIALS, AND ANY ACCOMPANYING HARDWARE.

7.NO LIABILITY FOR CONSEQUENTIAL DAMAGES. IN NO EVENT SHALL CABLETRON OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF BUSINESS, PROFITS, BUSINESS INTERRUPTION, LOSS OF BUSINESS INFORMATION, SPECIAL, INCIDENTAL, CONSEQUENTIAL, OR RELIANCE DAMAGES, OR OTHER LOSS) ARISING OUT OF THE USE OR INABILITY TO USE THIS CABLETRON PRODUCT, EVEN IF CABLETRON HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. BECAUSE SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, OR IN THE DURATION OR LIMITATION OF IMPLIED WARRANTIES IN SOME INSTANCES, THE ABOVE LIMITATION AND EXCLUSIONS MAY NOT APPLY TO YOU.

CABLETRON SYSTEMS LIMITED

PROGRAM LICENSE AGREEMENT

IMPORTANT: THIS LICENSE APPLIES FOR USE OF PRODUCT IN THE UNITED STATES OF AMERICA AND BY UNITED STATES OF AMERICA GOVERNMENT END USERS.

BEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCT,

CAREFULLY READ THIS LICENSE AGREEMENT.

This document is an agreement (“Agreement”) between You, the end user, and Cabletron Systems Limited (“Cabletron”) that sets forth your rights and obligations with respect to the Cabletron software program (“Program”) in the package. The Program may be contained in firmware, chips or other media. UTILIZING THE ENCLOSED PRODUCT, YOU ARE AGREEING TO BECOME BOUND BY THE TERMS OF THIS AGREEMENT, WHICH INCLUDES THE LICENSE AND THE LIMITATION OF WARRANTY AND DISCLAIMER OF LIABILITY. IF YOU DO NOT AGREE TO THE TERMS OF THIS AGREEMENT, RETURN THE UNOPENED PRODUCT TO CABLETRON OR YOUR DEALER, IF ANY, WITHIN TEN (10) DAYS FOLLOWING THE DATE OF RECEIPT FOR A FULL REFUND.

vi

HSIM-W85 User’s Guide

Image 8
Contents HSIM-W85 Page HSIM-W85 User’s Guide FCC Notice Vcci Notice HSIM-W85 User’s Guide HSIM-W85 User’s Guide Cabletron Systems Limited Program License Agreement HSIM-W85 User’s Guide Vii Viii HSIM-W85 User’s Guide Contents Contents Important Notice Chapter IntroductionFirmware Revision Using this Manual Overview ImuxFeatures Data Flow in the HSIM-W85Connectivity HdlcInverse Multiplexing Imux Priority QueuingSnmp and MIB Support 5 DS1 AlarmLanview Diagnostic LEDs Document Conventions Following conventions are used throughout this documentRelated Documentation Related DocumentationGetting Help Your email addressChapter Installation Unpacking the HSIM-W85Installing the HSIM-W85 Installing the HSIM-W85 in an Interface ModuleInstalling the HSIM-W85 Installing the HSIM-W85 Installing the HSIM-W85 in a Standalone Device Connecting the HSIM-W85 to the Network Figure B-3 HSIM-W85 Cable ConnectionChapter Lanview LedsLanview LEDs Chapter Management Local ManagementManagement Network Tools Commands Network Tools Help Screen Command Built-in Commands ImuxExample Wanpq WanpqDs1alarm Syntax ds1alarmDs1alarm Dsx1Dsx1 Ds1ext Syntax ds1extSpecial Commands Done, quit, exitSample Imux Configuration 3shows the imux setup for group id 1 so farEnabling the Imux Group Sample Imux Configuration Management HSIM-W85 User’s Guide Hardware Troubleshooting Chapter TroubleshootingTroubleshooting the HSIM-W85 Status S LED is OFF Investigating Software Configuration Problems Problems with the Firmware ImageHSIM-W85 User’s Guide Appendix a Specifications Physical PropertiesEnvironmental Requirements Regulatory ComplianceAppendix B Typical Configuration Appendix B Typical Configuration Appendix C FCC Part 68 USER’S Information Port IDAppendix C FCC Part 68 User’s Information Being duly sworn, state My commission expires

W85 specifications

Cabletron Systems W85 is a prominent networking solution that was developed to support the burgeoning demand for high-performance data communications in the enterprise environment. As an advanced multi-layer switch, the W85 effectively integrates various networking technologies, offering robust support for both wired and wireless connectivity, making it particularly suitable for complex network infrastructures.

One of the standout features of the W85 is its scalability. Designed to grow with the needs of a business, the W85 can accommodate an increasing number of users and devices without sacrificing performance. This is essential in today's digital workspace, where employees and equipment are continually being added to the network.

The W85 operates across multiple layers of the OSI model, offering Layer 2 and Layer 3 switching capabilities. Layer 2 functionalities enable efficient Ethernet switching and VLAN support, ensuring that data can move swiftly within local networks. Meanwhile, its Layer 3 capabilities facilitate dynamic routing, allowing for intelligent data distribution across different network segments. This dual functionality enhances the W85's versatility, making it suitable for both small and large-scale deployments.

Equipped with advanced security features, the Cabletron W85 places a strong emphasis on network integrity. It supports comprehensive security protocols that help to mitigate potential threats. Features such as Access Control Lists (ACLs) allow administrators to define and enforce security policies, ensuring that only authorized users have access to sensitive data. Furthermore, the device supports advanced encryption methods to protect data in transit, which is crucial for safeguarding information in modern enterprises.

The W85 is also notable for its management capabilities. It provides an intuitive web-based interface for system administrators, simplifying the configuration and monitoring processes. With support for SNMP (Simple Network Management Protocol), administrators can efficiently manage network devices and receive alerts for potential issues before they escalate into significant problems.

In terms of connectivity, the Cabletron W85 features multiple Gigabit Ethernet ports designed to handle high-speed data transfer. This allows for seamless integration with existing infrastructure while ensuring that performance remains high even under heavy loads. The device is also compatible with various network management protocols, positioning it as a streamlined component in any enterprise’s networking strategy.

The Cabletron Systems W85 embodies the future of enterprise networking with its combination of scalability, security features, and robust management tools, ensuring it remains a relevant choice for organizations looking to enhance their networking capabilities.