Cabletron Systems STH-24 manual Installation

Page 14

Installation

Plastic Tab

Jack for ESD

Wrist Strap

Metal Back-Panel

Module

Module Guides

Warning:

Ensure that the circuit card is between the card guides.

Lock down the top and bottom plastic tabs at the same time, applying even pressure.

Figure 2-1. Installing the MicroLAN Module

2-2

Image 14

Contents SmartSwitch 9T122-24 User’s Guide Page Page DOC Notice FCC NoticeVcci Notice Declaration of Conformity Addendum Page Contents Contents Features IntroductionManagement Information Base MIB Support 9T122-24 MicroLAN Module Related Manuals Getting HelpInstallation Installing the MicroLAN ModuleInstallation Reset Switch Reset SwitchUser-Accessible Components SMB-1 PromSetting the Module Card DIP Switch Location of Module DIP SwitchRing Speed See the Cautions at the end of this tableUsing a Ring-Out Port Multi-Ring Out CapabilityInstallation T122-24 Block Diagram OperationBridging Transparent BridgingSource Route Bridging Flexible Network Bus FNB System Management BusesFNB Interface System Diagnostic ControllerDC/DC Converter I960 CoreOperation Lanview LEDs Lanview LEDsFunctions of the FNB receive LED are listed in Table Functions of the Link LED are listed in Table Function of the Token Ring speed LEDs is listed in Table Speciﬁcations SafetyService Physical Electrical