Cabletron Systems STH-24 manual FCC Notice, Vcci Notice, DOC Notice

Page 4

Notice

FCC Notice

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

VCCI Notice

This is a Class A product based on the standard of the Voluntary Control Council for Interference by Information Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, the user may be required to take corrective actions.

DOC Notice

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

ii

Image 4
Contents SmartSwitch 9T122-24 User’s Guide Page Page Vcci Notice FCC NoticeDOC Notice Declaration of Conformity Addendum Page Contents Contents Features IntroductionManagement Information Base MIB Support 9T122-24 MicroLAN Module Related Manuals Getting HelpInstallation Installing the MicroLAN ModuleInstallation Reset Switch Reset SwitchUser-Accessible Components SMB-1 PromSetting the Module Card DIP Switch Location of Module DIP SwitchRing Speed See the Cautions at the end of this tableUsing a Ring-Out Port Multi-Ring Out CapabilityInstallation T122-24 Block Diagram OperationBridging Transparent BridgingSource Route Bridging Flexible Network Bus FNB System Management BusesSystem Diagnostic Controller DC/DC ConverterFNB Interface I960 CoreOperation Lanview LEDs Lanview LEDsFunctions of the FNB receive LED are listed in Table Functions of the Link LED are listed in Table Function of the Token Ring speed LEDs is listed in Table Service SafetySpecifications Physical Electrical