Cabletron Systems ESXMIM-F2 manual FCC Notice

Page 4

Notice

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

DOC NOTICE

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

VCCI NOTICE

This equipment is in the 1st Class Category (information equipment to be used in commercial and/or industrial areas) and conforms to the standards set by the Voluntary Control Council for Interference by Information Technology Equipment (VCCI) aimed at preventing radio interference in commercial and/or industrial areas.

Consequently, when used in a residential area or in an adjacent area thereto, radio interference may be caused to radios and TV receivers, etc.

Read the instructions for correct handling.

ii	ESXMIM/ESXMIM-F2 Local Management Guide

Image 4

Contents Local Management Guide Page ESXMIM/ESXMIM-F2 Local Management Guide FCC Notice Cabletron SYSTEMS, INC. Program License Agreement United States Government Restricted Rights Contents Contents ESXMIM/ESXMIM-F2 Local Management Guide Vii Contents Viii ESXMIM/ESXMIM-F2 Local Management Guide Chapter Introduction Using this ManualManual Organization Document Conventions Following conventions are used throughout this documentGetting Help Local Management OverviewIn-Band vs. Out-of-Band Management AgentLocal vs. Remote Management Local Management Requirements Local Management Screen Elements Saved OKFollowing list explains each of the Local Management ﬁelds Local Management Keyboard Conventions Keyboard Conventions FunctionNavigating Local Management Screens Navigating Local Management ScreensESXMIM/ESXMIM-F2 Local Management Guide Configuring a Local Management Terminal Chapter Local Management RequirementsManagement Terminal Setup Requirements Terminal Setup Parameters Menu Function SelectionCable Conﬁguration for the Management Terminal Establishing a Telnet Connection Chapter Accessing Local Management Using the Menu ScreensShows the hierarchy of Local Management screens Selecting Local Management Menu Screen Items Hierarchy of Local Management ScreensExiting Local Management Screens Exiting the Local Management SessionMain Menu Screen Event Message LineSetup Menu Screen Setup Menu ScreenSetup Menu Screen Status Menu Screen Esxmim does not use the Chassis Status screenStatistics Menu Screen Statistics Menu ScreenESXMIM/ESXMIM-F2 Local Management Guide Chapter System Level Screen System Level Screen FieldsNone Defined Setting the System Date Setting the System TimeSetting the Host IP Address Setting the Subnet Mask Setting the Subnet MaskSetting the Default Gateway Setting the Default InterfaceCOM Port Applications Cabletron Systems Local Management connectionsESXMIM/ESXMIM-F2 Local Management Guide Community Name Access Policy Chapter Snmp Community Names ScreenSetting Snmp Community Names Chapter Snmp Traps Screen Trap Table Screen FieldsSetting the Snmp Trap Destination Chapter Flash Download Screen RuntimeBootPROM Download Selecting a Flash Download MethodRuntime Download Selecting a Flash Download ServerChanging the Download File Name Changing the Download Server IPPerforming a Flash Download Operation Chapter Bridge Setup Screen Bridge Setup ScreenBridge Setup Screen Fields Selecting a Spanning Tree ProtocolSelecting the Port Administrative Status EnabledSelecting Bridge Port Pair Administrative Status Bridge Port Pair Admin Status Port 01 - Port 02 DisabledChapter Module Specific Setup Screen Module Speciﬁc Setup ScreenDevice Specific Setup Screen Fields Selecting Interface 1 Connection StatusChapter Component Status Screen Esxmim LIMComponent Status Screen Chapter Interface Statistics Screen Interface Statistics ScreenInterface Statistics Screen Fields Interface Statistics Screen Fields Selecting AN UPDATE-FREQ Clearing Statistics CountersSelecting AN Interface ESXMIM/ESXMIM-F2 Local Management Guide Chapter MIB Navigator Screen SpecialManaging Device Mibs Hierarchical MIB Tree StructureMIB Navigator Command SET Overview MIB Navigator command set provides the following commandsConventions for MIB Navigator Commands SyntaxNavigation Commands Ctron Mib2 Pwd Set OID value Su community name Whoami Built-In Commands MIBNav- arp -d 1Defroute interface number IP address OID Snmpget command enables you to query Snmpset IP address community name Snmptree IP address community name Special Commands Index Index-2 ESXMIM/ESXMIM-F2 Local Management Guide ESXMIM/ESXMIM-F2 Local Management Guide Index-3 Index Index-4 ESXMIM/ESXMIM-F2 Local Management Guide