Cabletron Systems 9T122-24 manual Reset Switch

Page 12

The Reset Switch

The Reset Switch

The Reset switch is located on the front panel, under the top plastic tab as shown in Figure 2-2.It serves two functions:

•Pressing the reset switch twice within three seconds causes the processor (i960) to reset.

•Pressing and holding the switch on for three or more seconds causes the module to shutdown. Pressing and holding again for three seconds restarts the module.

SNMP management may be used to disable this switch to enhance module security.

Reset Switch

Figure 2-2. The Reset Switch

2-3

Image 12

Contents Page Page FCC Notice Vcci NoticeDOC Notice Contents Features IntroductionManagement Information Base MIB Support Features Related Manuals Getting HelpInstallation Installing the MicroLAN ModuleInstallation Reset Switch User Accessible Components SMB-1 PromSetting the Module Card DIP Switch Location of Module DIP SwitchSwitch Function Description Ring Speed Multi-Ring Out CapabilityOperation BridgingTransparent Bridging Spanning Tree Algorithm Flexible Network Bus FNB System Management BusesSystem Diagnostic Controller DC/DC ConverterFNB Interface I960 CoreLanview LEDs Lanview LEDsLED Color State Description LED Color State Yellow 16 Mbs Off Mps Safety ServiceSpeciﬁcations Physical Electrical