Avenview FO-DVI-XX-MM specifications Connector Electrical Characteristics

2.7.2 Connector Electrical Characteristics

Item	Test Condition	Requirements
Contact Resistance	ANSI/EIA-364-23	20mΩ, maximum, initial per
		contact mated pair
		10mΩ, maximum change from
		original per contact mated pair
Shell Resistance	ANSI/EIA-364-06A-83	50mΩ, maximum initial
	Contact resistance measured from	50mΩ, maximum change from
	receptacle shell leg to plug cable	original
	braid. Test current = 100mA; Test
	Voltage = 5V DC open circuit
	maximum
Dielectric Withstanding Voltage	ANSI/EIA-364-20	No Flash-over, No Spark-over, No
	Test voltage 500V DC ± 50V	Excess Leakage, No Breakdown
	Method C, unmated and
	un-mounted Barometric pressure
	of 15 psi
Insulation Resistance	ANSI/EIA-364-21	1GΩ minimum between adjacent
	Test voltage 500V DC ± 50V	contacts and contacts and shell
	Method C, unmated and
	un-mounted
Contact Current Rating	ANSI/EIA-364-70, TP-70	1.5A minimum
	55°C, maximum ambient
	85°C, maximum temperature
	change
Applied Voltage Rating		40V AC(ms) continuous maximum,
		on any signal pin with respect to
		the shield
Electrostatic Discharge	IEC 801-2	No evidence of discharge to
	Test un-mounted from 1kV to 8kV	contacts. Discharge to the shell is
	in 1kV steps using 8mm ball probe	acceptable.

www.avenview.com 15