Extron electronic YCS 100 user manual Using the PMK 300 Projector Mount Kit, Extron PMK

Installation and Operation, cont’d

Using the PMK 300 Projector Mount Kit

The PMK 300 Multi-Product Projector Mount Kit (#70-374-01) mounts up to three quarter-rack width products to a projector ceiling mount pole. The YCS 100 can be mounted above the display device with the front panel facing either down or up. The quarter rack width plate can also be used to mount the YCS external desktop power supply.

Follow these steps to projector-mount the YCS 100 using the PMK 300:

1.	If necessary, remove the feet from the bottom of the YCS.
2.	Mount the YCS to one of the bracket’s three mounting
	plates. It can be vertically mounted facing either up or
	down, whichever you prefer. See figure 2-8, below.

Bracket

Brace

U-Bolt

Extron

PMK 300

Multi-product

Projector

Mount Kit

Figure 2-8 — Projector-mounting the YCS 100 using the PMK 300 Projector Mount Kit

•On the side mounting plates, the YCS is typically mounted on the outside of the bracket.

On the front mounting plate, the device is typically mounted on the inside of the bracket.

•For the YCS 100 unit, use two of the supplied

4-40 x 3/16" screws in opposite (diagonal) corners to secure the device to the bracket.

For the YCS power supply, use the two included tie wraps to strap the power supply to the bracket.

NThe PMK 300 has a hole in the bottom plate that allows the projector pole to be inserted through the center of the plate, rather than outside of the plate (see figure 2-9, below). To install the PMK 300 in this configuration, slide the bracket up from the bottom of the pole before the projector is installed on the pole.

Bracket

Brace

	Extron
U-Bolt	PMK 300

Multi-product Projector

Mount Kit

Figure 2-9 — Projector-mounting the YCS 100 using the PMK 300 with the projector pole passing through the center

2-8 YCS 100 • Installation and Operation YCS 100 • Installation and Operation 2-9