Extron electronic YCS 100 user manual AAppendix a

Page 15

Installation and Operation, cont’d

Figure 2-15 — Jumper on YCS 100 internal board

NWhen the YCS is delivered from the factory, a shunt is attached to one prong of the jumper. This shunt is used to enable the jumper in step 4.

4. Enable (close) the CR8 jumper by placing the shunt on both prongs, as shown below.

	Open	Closed
Figure 2-16 — Enabling the CR8 jumper
5.	Replace the YCS cover, using the screws that you removed.
6.	Connect and power on all attached devices, then power on
	the YCS 100.

YCS 100

AAppendix A

Speciﬁcations, Part Numbers,

and Accessories

Speciﬁcations

Included Parts

Accessories

2-16 YCS 100 • Installation and Operation

Image 15

Contents YCS Precautions 安全须知中文 Table of Contents YCS Table of Contents, cont’dAbout this Manual FeaturesApplication Diagram IntroductionIntroduction, cont’d TwoTabletop use Installation and OperationInstallation Overview Mounting the YCSBack of the rack mounting Installation and Operation, cont’dUsing the PMK 100 Mini Projector Mount Kit Furniture mountingProjector mounting Extron PMK For a typical 1.5 to 2.0 diameter pole You can use Rear Panel Wiring the Power ConnectorTroubleshooting Front PanelOperation AAppendix a Speciﬁcations Speciﬁcations, Part Numbers, and AccessoriesSpeciﬁcations, Part Numbers, Accessories, cont’d AccessoriesIncluded Parts Speciﬁcations, Part Numbers, Accessories, cont’d