Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under no
|
| circumstances should you try to repair the set yourself, as this will | |
|
| invalidate the guarantee. | |
Problem |
| Note: | |
– | Possible cause |
| Make sure the CD is not encoded with copy- |
| right protection technologies, as some do not | ||
• | Remedy |
| |
| conform to the Compact Disc standard. | ||
No sound /power
The CD skips tracks
–Volume not adjusted
• | Adjust the VOLUME | – | CD damaged or dirty | |
• | Replace or clean CD | |||
– | Power cord not securely connected | |||
– Program/shuffle is active | ||||
• Connect the AC power cord properly | ||||
• | Exit program/shuffle mode | |||
– Batteries dead/ incorrectly inserted | ||||
|
| |||
• | Insert (fresh) batteries correctly | Note: A CD badly scratch or dirty may result in | ||
– | Headphones connected to the set | improper operation. | ||
•Disconnect headphones.
– CD contains
•Press ∞ , § once or more to skip to a CD audio track, instead of the data file.
Display does not function properly / No reaction to operation of any of the controls
–Electrostatic discharge
•Switch off and unplug the set. Reconnect after a few seconds
--, Er or 01 indication
–No CD inserted
• Insert a CD
–CD badly scratched or dirty
•Replace/clean CD, see Maintenance
– Laser lens steamed up
•Wait until lens has cleared