Extron electronic MVX 88 Series manual Example 2 Add a video tie to a set of video and audio ties

Example 2: Add a video tie to a set of video and audio ties

In the following example, a new video tie is added to the current configuration. The example shows the front panel indications that result from your actions.

NThis example assumes that you have performed example 1.

1. Select video only for the tie (figure 3-8).

Press the button to cycle through the selections.

I/O

The video LED lights when video is selected. VID

The audio LED is off when audio is deselected. AUD

Figure 3-8 — Select video only

2. Press and release the Input 5 button (figure 3-9).

Press and release the Input 5 button.

4	INPUTS			2		4	OUTPUTS
	5	6	1		3		5	6	7	8

The Input 5 LED lights to			The Output 3, Output 4, and Output 8 LEDs light to indicate the ties created in
indicate that input 5 is selected.			example 1.
Figure 3-9 — Select an input
3.	Press and release the Output 1 button (figure 3-10).
		Press and release the Output 1 button.
			OUTPUTS

1 2 3 4 5 6 7 8

The Output 1 LED blinks to indicate that the selected input will be tied to this output.

= Blinking LED

Figure 3-10 — Select the output

4.	Press and release the Enter button (figure 3-11).
	Press the Enter button to	The LEDs for the selected input, the selected outputs,
	confirm the configuration	and the tied outputs light steadily for approximately 1
	change.	second to indicate the tie and then go out.
		INPUTS		OUTPUTS
	ENTER	5	1	3	4	8

1 second

Figure 3-11 — Press the Enter button

PRELIMINARY

MVX 44 / 48 / 84 / 88 VGA Matrix Switchers • Operation 3-9