Extron electronic TLP VIM manual Operation, Video Inputs

DVideo input –Two female BNC connectors on pigtails used to input either S-video (yellow-chroma, white-luma) or composite video (white only).

For composite input, connect the composite cable to the white video input cable.

		12V
For S-video input	White: Luma or	0.5A MAX	AUD
connect the luma cable	Composite
to the white video
input and the chroma
cable to the yellow
video input.
		Yellow: Chroma
	Figure 5.	Video Inputs

EMTP output –One female RJ-45 connector to output the MTP A/V signal to the touchpanel.

The TP cable connecting the TLP VIM output to the MTP input of the touchpanel is standard UTP or STP Cat 5 or better cable. The ends may be terminated using either TIA/EIA 568A or TIA/EIA 568B but both ends must use the same standard.

	Pins:		T568A	T568B	MTP Signal	MTP Signal
12345678		Pin	Wire Color	Wire Color	Composite	S-video
		1	White-green	White-orange	Reserved	Chroma+
		2	Green	Orange	Reserved	Chroma–
		3	White-orange	White-green	Mono audio+	Mono audio+
		4	Blue	Blue	Video+	Luma+
		5	White-blue	White-blue	Video–	Luma–
		6	Orange	Green	Mono audio–	Mono audio–
	Insert	7	White-brown	White-brown	Reserved	Reserved
		8	Brown	Brown	Reserved	Reserved
TP Wires

NOTE: When using Enhanced Skew-Free™ A/V cable, use the TIA/EIA T568A standard only.

CAUTION: The TLP VIM output uses higher voltages than a LAN. Inputting those voltages on a LAN communications port may damage the connection.

Operation

No setup or configuration is required. Once cabling is complete, apply power to the connected equipment and TLP VIM. The unit is ready for operation.

6TLP VIM • Installation and Operation