Extron electronic 68-388-01 manual Remote Operation, See inset top, right To install batteries

Operating the System 5cr • Chapter 3

Remote Operation

________ See inset (top, right)

to install batteries.

The System 5 includes one infrared remote control (IR 40)

and can have one or two optional remote control panels (SCP 100). Each of these

devices replicate the front panel controls

for normal operation. Learning and other things done in Setup Mode cannot be done from these remote devices. The IR 40, shown in Figure 3-3, uses + and - buttons for Volume up and down.

The Function and Enter buttons on the IR 40 do not affect the System 5 operation.

Figure 3-3. The IR 40 has the same controls as the front panel.

The optional SCP 100 panels can be mounted in a wall or piece of furniture, such as a desk or podium. In addition to duplicating front panel controls, they also receive IR 40 signals and pass them to the System 5. Infrared signals from other devices are blocked at the System 5, and do not pass on to the IR emitter or broadcaster.

Figure 3-4. The optional SCP 100 also passes IR 40 signals to the System 5.

Other ways to control the System 5 include using the RS-232 serial port. This can be through a host, such as a touch-screen panel or a PC, using the Windows® operating system. RS-232 programming is covered in Appendix A of this manual.

Certain operations can be done only through Extron’s System 5cr Control

Program, these include:

• Room Relay Mode (Latched/Momentary)

•(projector) Power Up/Down Delay times

•Auto Set Attenuators (set all audio input to the same level).

The use of Extron’s Windows® Control Program is covered in Chapter 4 and RS-232 programming is in Appendix A.

3-5 Extron • System 5cr Switcher • User’s Manual