Extron electronic TPS150 manual Audio TPT150 only

Page 47

Standards

NTSC 3.58, NTSC 4.43, PAL, SECAM

Input level

2.3 V to 4.6 V p-p, unterminated

Output level

3.2 V to 4.6 V p-p, unterminated

Input impedance

510 ohms

Output impedance

75 ohms

Max. input voltage

4.6 V p-p

Max. propagation delay

760 ns

Max. rise/fall time

35 ns

Polarity

Negative

Audio — TPT150 only

Gain

-30dB to +9dB, adjustable

Frequency response

20 Hz to 20 kHz, ±2.4dB

THD + Noise

0.04% @ 1 kHz at nominal level

S/N

>-96dB at maximum output

Crosstalk

<-93dB @ 20 kHz, fully loaded

Stereo channel separation

>-90dB @ 1 kHz

Audio input — TPT150 only

Number/signal type

4 stereo, unbalanced

Connectors

4 pairs of RCA connectors

Impedance

>7.8k ohms unbalanced, DC coupled

Nominal level

2.22dBu (1 Vrms)

Maximum level

+10.1dBu, (unbalanced) at 1%THD+N

0dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV 2dBu

Audio output — TPT150 only

Number/signal type

1 stereo, balanced/unbalanced

Connectors

(1) 3.5 mm captive screw connector, 5 pole

Impedance

51 ohms unbalanced

Gain error

±0.03dB channel to channel

Maximum level (Hi-Z)

>+10.2dBu, balanced or unbalanced at 1%THD+N

Maximum level (600 ohm)

>+4.2dBm, balanced or unbalanced at 1%THD+N

Control/remote — transmitter (TPT150)

Serial control port

RS-232, 9-pin male D connector

Baud rate and protocol

38400, 19200, 9600 (default), 4800, 2400, or 1200 baud (configurable); 8 data

 

bits; 1 (default) or 2 stop bits; no parity (default), or even or odd parity

Serial control pin configurations

2 = RX, 3 = TX, 5 = GND

Contact closure

(1) 3.5 mm captive screw connector, 8 pole for a CTP150CM control panel or

 

locally constructed device

Contact closure pin configurations

1 = input 1, 2 = input 2, 3 = input 3, 4 = input 4, 5 = volume up,

 

6 = volume down, 7 = projector power, 8 = GND

Program control

Inline Control Software for Windows® – lCS100

Control — projector (TPR only)

Projector control port

RS-232, 9-pin male D connector

Baud rate and protocol

38400, 19200, 9600 (default), 4800, 2400, or 1200 baud (configurable); 8 data

 

bits; 1 (default) or 2 stop bits; no parity (default), or even or odd parity

TPS150 Switching and Transmission System • Reference Information

A-3

Image 47
Contents TPS150 Twisted Pair A/V Switching and Transmission SystemInstrucciones de seguridad Español Safety Instructions EnglishConsignes de Sécurité Français Sicherheitsanleitungen DeutschInputs 3 TPS150 Switching and Transmission System Quick Start QS-1Inputs 1 and 2 Connect Output 1 Connect a Quick Start TPS150 Switching and Transmission SystemVolume and buttons QS-2 TPS150 Switching and Transmission System Quick StartTable of Contents Table of Contents, cont’d One About this Manual About the TPT150 switching transmitterTPS150 Switching and Transmission System Introduction Introductiontroduction, cont’dAbout the TPR150 receiver Serial RS-232 commands on one male DB9 connectorTP Cable Advantages Video format Maximum range FeaturesIntroduction, cont’d Transmission distanceTPS150 Switching and Transmission System Introduction Introduction, cont’d Two Rack mounting the transmitter Installationstallation, cont’dTPS150 Switching and Transmission System Installation Mounting the Transmitter and ReceiverVideo and audio input connections Cabling and Rear Panel ViewsTransmitter connections TP and audio output connections Installation, cont’dTP input connection Remote control connectionsPower connection Receiver connectionsSerial connection TP Cable TerminationVideo output connections Three Operationeration, cont’d Controls and IndicatorsTransmitter controls and indicators TPS150 Switching and Transmission System OperationTPR150 receiver front panel Receiver controls and indicatorsOperations PowerProjector power Operation, cont’dOutput volume Volume adjustmentFull system reset Receiver resetOptimizing the Video General checks TroubleshootingAppears Specific problemsProblem Possible cause Solution No image appears Distorted imageFour System requirements Installing the softwareSerialCommunicationsunications, cont’d ICS100 Windows-Based Control ProgramICS100 program window and connected message Establishing communications with the programAgain Serial Communications, cont’dConnected window Using the software to configure the serial port settings For each input or projector code to be programmed Using the software to program the input and projector codesCode entry Ascii code Window appears figure Using the software to operate the transmission systemButton mutes and unmutes the audio output Using the help systemAddressing the transmitter Serial CommandsCommand and response structure Communication protocolsR1addressecho of the command sent Using the command/response tableSymbols R0addressecho of the command sentSpaces between bytes are not allowed Addressing Command Ascii Command Response Additional descriptionInput audio level Response Additional description CommandFront panel lockout Serial Communications, cont’d AAppendix a Reference Information SpecificationsAudio TPT150 only General Reference Information, cont’dIncluded parts Optional accessoriesAccessory Part number Part NumbersReference Information, cont’d Asia Japan FCC Class a Notice Extron’s WarrantyExtron Electronics, USA
Related manuals
Manual 54 pages 58.58 Kb

TPS150 specifications

The Extron TPS150 is a highly regarded touch panel system designed for professional AV environments, providing an intuitive interface for controlling various audio and video components. This device is part of Extron's popular TouchLink Pro series, which is known for its robustness and versatility in managing classroom and conference room technology.

One of the standout features of the TPS150 is its high-resolution capacitive touch screen, which measures at 15 inches. This screen delivers vibrant colors and exceptional clarity, ensuring that users can easily interact with the device even in well-lit environments. The touch panel's interface is fully customizable, allowing users to create a layout tailored to their specific needs. This customization can include the addition of buttons, sliders, and dynamic graphics that make navigation seamless and user-friendly.

In terms of connectivity, the TPS150 supports Ethernet communication, which enables easy integration with networked AV systems. This feature allows for remote access and control, making it easier for IT professionals to monitor and manage AV devices from a centralized location. Additionally, the TPS150 is compatible with various Extron control systems, providing a robust platform for managing complex multimedia setups.

The device also incorporates advanced security features, ensuring that sensitive system controls are protected from unauthorized access. Administrators can establish user permissions and authentication processes to maintain control over the AV environment, which is particularly important in corporate and educational settings.

Moreover, the TPS150 supports Extron's global configurator software, which simplifies the setup process and allows for easy programming of touch panel interfaces. Users can design custom layouts quickly and efficiently, and the software also provides an extensive library of drivers for popular AV equipment, enhancing compatibility and functionality.

With its elegant design, high-quality components, and customizable interface, the Extron TPS150 touch panel offers an effective solution for AV control. Whether used in educational, corporate, or professional environments, it empowers users to streamline their audiovisual experiences and maintain effective control over their technology, ensuring successful presentations and meetings.