Extron electronic GSS 100 user manual RGB Delay submenu, Slide Show menu, Sync format submenu

Operation, cont’d

Resolution	50	60	72	96	100	120
	Hz	Hz	Hz	Hz	Hz	Hz
640 x 480	•	•	•	•	•	•
800 x 600	•	•	•	•	•	•
852 x 480	•	•	•	•	•
1024 x 768	•	•	•	•
1024 x 852	•	•	•	•
1024 x 1024	•	•	•
1280 x 768	•	•
1280 x 1024	•	•
1360 x 765	•	•
1365 x 768	•	•

RGB Delay submenu

The GSS can briefly blank the RGB (video) output while it switches between the stored image and the pass-through image. This allows the change in display to appear without a glitch. RGB delay is also known as Triple-Action Switching or video mute switching.

Rotate the Adjust/Select knob while in the RGB Delay submenu to set the delay between 0 to 5 seconds, in 0.1-second increments. No delay (0.0 seconds) is the default setting.

Slide Show menu

Figure 3-9 is a flowchart that shows an overview of the Slide Show menu and the available settings.

Power Default

on Cycle

1366 x 768	•	•
1365 x 1024	•	•
1400 x 1050	•	•
480p	•	•
576p	•	•
720p	•	•
1080i	•	•
1080p	•	•

Sync format submenu

Rotate the Adjust/Select knob while in the Sync format submenu to select the sync format for the still image output.

	Menu
10
sec.	Switch
	Effect
10	Menu
sec.	Output
	Config
10	Menu
sec.	Slide
	Show
10	Menu
sec.	Advanced
	Menu
10	Menu
sec.	Exit
Menu
	Menu

	Menu	10 sec.		Menu	10 sec.
Next	Duration	Next		PassThru	Next
	030 Secs			Disabled
	Duration		Pass-Thru Input
0 to 300 seconds in			•	Disabled
1 second increments			• Enabled

RGBHV is the default selection.

Sync polarity submenu

Rotate the Adjust/Select knob while in the Sync polarity submenu to select the sync polarity (positive and negative) for the still image output. Horizontal and vertical negative sync are the default selection.

Figure 3-9 — Slide Show submenu flowchart

Duration submenu

Rotate the Adjust/Select knob while in the Duration submenu to set the duration of each displayed image in the slide show between 0 and 300 seconds, in 1-second increments. The default duration is 30 seconds.

NThe actual time that an image is displayed may vary, based on the decoding time of the next image in the slide show.

Pass-Thru submenu

Rotate the Adjust/Select knob while in the Pass-Thru submenu to enable or disable the inclusion of the pass-through input as part of the slide show. The pass-through input is disabled from being part of the slide show by default.

3-8 GSS 100 Graphic Still Store • Operation GSS 100 Graphic Still Store • Operation 3-9