Cables to Go KNV104D, KNV108D, KNV116D Installation, Device Connection, Master console connection

Page 4

------------------------ Installation

Device Connection

The monitor connected to the HD-DB-15 VGA port of a Master CONSOLE must be multisync capable of synchronizing with the computer's video signal. If you are uncertain about the monitor type, please consult the monitor user's manual. Connect a PS/2 mouse and a keyboard to the CONSOLE port marked with a mouse and a keyboard respectively as shown in figure 3. [NOTE: Only a PS/2 mouse can be connected to the CONSOLE mouse port. The KVM Switch automatic mouse conversion system allows you to connect computers using serial mouse and control the computers from one PS/2 mouse.]

Figure 3: Master console connection

Image 4

Contents One-Console KVM Switches Two-Console KVM SwitchesIntroduction OverviewFeatures Extra features for On-Screen Display modelMore features for multi-access models Automatic Mouse ConversionConfigurations Single KVM Switch ConfigurationCascade Master/Slave Configuration Figure 1 A single KVM Switch configurationDevice Connection InstallationFigure 3 Master console connection Initial Power-Up Replace Master Console DevicesAdhesive Rubber Foot Figure 4 Master computer connectionFigure 6 Attaching rack mount bracket Optional Rack Mount AccessoriesFigure 7 Assembling rack cable support Multimedia Module OperationFront Panel Push Buttons K/M RESETKNV104D,KNV108D,KNV116D,KNV2108D,KNV2116D OSD On-Screen-Display OperationFigure 9 OSD screen illustration Ready PC In Scan mode, scan through power-on Auto ScanManual Scan Audio StickScan Rate Keyboard SpeedHotkey Menu CH DisplayHot-key commands Cascade Configuration ConnectionFigure 11 Cascaded 4-port KVM Switches Figure 12 Cascaded 8-port KVM SwitchesMulti-access KVM Switch Change Configuration while RunningConnections For OSD modelConfiguration SpecificationsOperation AppendicesTroubleshooting SymptomPossible causes Recommended solutions the MasterLimited Warranty