Cables to Go KNV116D Initial Power-Up, Replace Master Console Devices, Adhesive Rubber Foot

Page 5
Figure 4: Master computer connection

Determine the port address of each computer. For computers using PS/2 mouse, connect the computer's mouse and keyboard cables to the KVM Switch connectors marked with a mouse and keyboard respectively, as shown in figure 4.

Figure 4: Master computer connection

For computers using serial mouse, connect the DB-9 to mini-DIN-6 adapter (supplied with the KVM Switch) to the computer mouse port, then use PS/2 cables to connect the mouse to KVM Switch, see figure 5. Connect the computer's monitor cable to the HD-DB-15 VGA connector. Repeat above steps for all remaining computers to be connected to the KVM Switch.

Figure 5: Adapter and serial mouse connection

8

Initial Power-Up

Make sure all computers and KVM Switches are powered down during installation. You must power up the Master KVM Switch before turning on any other devices.

For single KVM Switch: 1) Apply a power adapter to the Master. 2) Turn on computers.

For cascade: 1) Apply a power adapter to the Master.

2)Apply power adapters to all Slaves. 3) Turn on computers.

Note: You may hot plug additional powered-down computer and Slave without turning any existing KVM Switch or computer off after initial power up.

Replace Master Console Devices

You can replace a faulty keyboard or mouse of the Master CONSOLE port at any time without powering down the Master, as long as your computers are booted with proper device driver for the new device. Should you encounter any difficulty, just activate K/M RESET by holding both front-panel ‘1’ and ‘2’ push buttons down for 2 seconds.

Adhesive Rubber Foot

For desk-top operation, you may stick the four round rubber feet (supplied with the unit) to the bottom of the KVM Switch. NOTE: Do not use the rubber feet for rack mount operation. Give the rubber feet a firm press to prevent them from getting loose.

9

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Two-Console KVM Switches One-Console KVM SwitchesIntroduction OverviewExtra features for On-Screen Display model FeaturesMore features for multi-access models Automatic Mouse ConversionSingle KVM Switch Configuration ConfigurationsCascade Master/Slave Configuration Figure 1 A single KVM Switch configurationFigure 3 Master console connection InstallationDevice Connection Replace Master Console Devices Initial Power-UpAdhesive Rubber Foot Figure 4 Master computer connectionFigure 7 Assembling rack cable support Optional Rack Mount AccessoriesFigure 6 Attaching rack mount bracket Operation Multimedia ModuleFront Panel Push Buttons K/M RESETFigure 9 OSD screen illustration OSD On-Screen-Display OperationKNV104D,KNV108D,KNV116D,KNV2108D,KNV2116D Auto Scan Ready PC In Scan mode, scan through power-onManual Scan Audio StickKeyboard Speed Scan RateHotkey Menu CH DisplayHot-key commands Connection Cascade ConfigurationFigure 11 Cascaded 4-port KVM Switches Figure 12 Cascaded 8-port KVM SwitchesChange Configuration while Running Multi-access KVM SwitchConnections For OSD modelSpecifications ConfigurationOperation AppendicesSymptom TroubleshootingPossible causes Recommended solutions the MasterLimited Warranty
Top Page Image Contents