Gigabyte GO-RAMDISK-BOX-RH user manual Product Specifications, Product Requirements

Page 4

English

2. Product Specifications

zConvenience to use for both PC and Server .

zSATAInterface

-SATA 1.0a Compliant

-Supports one SATA connector

-Up to 150MB/s data transfer rate z Memory Interface

-Max amount of memory supported is 4GB

-Four 184-Pin/2.5V DDR DIMM sockets

-Supports DDR 266/333/400(Note 2)

-Supports DIMM up to 4.2mm thickness (including heat-sink) z Backup Battery

-One 1,700mAh lithium battery

3. Product Requirements

zOne available SATA (1.5Gb/s) compliant connector

zSystems based on Intel ICH6 / ICH7 / ICH8 / C19 series, VIA 8237A / VIA8237R /

VIA 8237R+ series, SiS 964, nVIDIA MCP51 / MCP55 / MCP61 / CK804 South Bridge.

(Note 2): Please refer to the recommended memory support list on Page 9.

If the i RAM box temperature is too high(over 50oC), then it could cause the battery to over heat prompting to battery bulging. This can also affect the battery to be unable to charge and discharge power normally.

The data in the i-RAM will be lost when the battery has no more power. - 4 -

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Copyright Rev 24MD1-IRMBOX-02RTable of Contents Product Features Product Specifications Product RequirementsPower ConnectorProduct Introduction Front Panel Rear PanelPrecautions General PrecautionsImportant Battery Information Data Loss PreventionsInstallation Directions Install i-RAM BOX into the system 5V SB connectorSata connector Put i-RAM box into the 5.25 inch cd-rom driveSoftware Setup Configure System Bios Appendix Recommended Memory Support ListFormat i-RAM Please refer to the memory support list belowDDR400 1GB IRAM EasyBackup utility introduction English Rev RAM Sata 1.0a i-RAM DDR DDR 266/333/400 3D/2D RAM Standby Power Sata 1.0aRAM Sata 1.0aSata 5V SB Page RAM RAM BOX SataBios Bios RAM Sata i-RAMRAM RAM i-RAM Fdisk Windows i-RAMDDR400 1GB IRAM EasyBackup Wondows
Top Page Image Contents