Gigabyte GO-RAMDISK-BOX-RH user manual Installation Directions

6. Installation Directions

Each time before setting up the i-RAM, make sure to remove system power and the i-RAM battery to prevent damage.

Please read the following installation directions before using i-RAM:

English

Hardware Installation 8-1 : Open the cover

Please remove the four screws on the cover (Figure a ), then pull up the cover (Figure b).

8- 2: Install Memory Module(s)

Place i-RAM card on an anti-static pad.

The DIMM socket has a notch, so the memory module can only fit in one direction. Push the clips at both end of the DIMM socket outwards to the open position(Figure c). Insert the memory module into the DIMM socket. Then push it down until the retaining clips snap into place (Figure d). We recommend slotting memory modules from the top socket. Replace the i-RAM battery after inserting the memory module(s).

8- 3: Install Battery

Please make sure that the battery is properly installed to the battery socket. The 3 gold pins of the battery should be at the same direction with the battery socket pins direction.

Figure c

Figure d

Anode