English
5)IDE1/ IDE2 (IDE1/IDE2 Connector) | Ø Important Notice: |
| Please connect first harddisk to IDE1 and |
| connect CDROM to IDE2. |
| The red stripe of the ribbon cable must be the |
IDE2 | same side with the Pin1. |
| |
1 |
|
1 |
|
IDE1 |
|
6)FDD (Floppy Connector) | Ø Please connect the floppy drive ribbon cables |
| to FDD. It supports 360K,720K,1.2M,1.44M |
| and 2.88Mbytes floppy disk types. |
| The red stripe of the ribbon cable must be the |
| same side with the Pin1. |
1
7)RAM_LED
- +
8)PWR_LED
MPD+
MPD-
MPD-
1
ØDo not remove memory modules while DIMM LED is on. It might cause short or other unexpected damages due to the
2.5V stand by voltage. Remove memory modules only when AC Power cord is disconnected.
ØPWR_LED is connect with the system power indicator to indicate whether the system is on/off. It will blink when the system enters suspend mode.
If you use dual color LED, power LED will turn to another color.
- 18 - |