BenQ AWL-500 user manual FCC Warning

Page 3

Notice II

FCC Warning

The AWL-500 compiles with Part 15 of the FCC rules.

Operation is subject to the following two conditions.

(1)This device may not cause harmful interference.

(2)This device must accept any interference received, including interference that may cause undesired operation.

Note:

The AWL-500 has been tested and found to comply with the limits for a Class B digital device and a low power transmitter, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

BENQ Corporation

Image 3
Contents Version June Wireless LAN Access Point AWL-500Trademarks Copyright StatementFCC Warning Table of Contents Introduction System Requirements Product KitMechanical Description Top panel of the Access PointBack panel of the Access Point Power Socket10/100Mbps Ethernet Ports Hardware Installation Plug the Power CableConnect the Ethernet Cable Using the Access Point Search Tool Configuring the Access PointDescription Change IP Address Using the Web Management Quick Installation Wizard Statistics InformationAssociated Table Security Setup Advanced SettingAccess Control 802.1x Security setup EAP Authenticate Parameter Radius Accounting Parameters User AccountBenq Corporation Reboot System Save SettingWeb Language Firmware UpgradeLoad Default Setting