ATTO Technology 3400 operation manual Symbol Indicates, Telnet session Screen, Explanation

Page 19

Exhibit 7-3 Command conventions. Do not type symbols when entering commands.

Symbol		Indicates

[	]	Required entry

	•	Space character (ASCII 32 decimal)

<	>	Optional entry

		pick one of

…		Ellipses, repetition of preceding item

	\n	end of line

	–	a range (6 – 9 = 6, 7, 8, 9)

Boldface words		must be typed as they appear

Italicized words		Parameters which must be replaced by whatever they represent

RACK 000 or 000		required parameters

LL		Hub zone [ 01 02 03 ]

	C	Channel or port number
		such as [ 2 3 4 5 6 7 8 ] in single-zone (Zone 1) configuration

Exhibit 7-4 A typical command/response sequence during a Telnet session.

Telnet session

screen

setup•000:0120

OK

$

switch

OK

$

Explanation

Prepares to connect port 1 to port 2 in zone 1

Valid input, accepted

Telnet prompt: ready for next command. Type the next command immediately after the prompt ($ switch)

Implements changes to the hardware configuration, connecting port 1 to port 2 in zone 1

Connection complete

Telnet prompt: ready for next command

Secure Data Path Applicationv 14

Image 19

Contents Atto FibreCenter Secure Data Path Application Page Page Contents Configuration commands Glossary Fibre Channel is a key technology for storageTerm Definition LED Quick start instructions Atto FibreCenter supports diverse SAN needsZone Port Local and network management Atto FibreCenter 3400 characteristicsSpecifications FeaturesSecure Data Path Applicationv Setting up the FC Rack System Removing a power module Installing a power moduleInstalling the FibreCenter Setting up the Atto FibreCenterTo change the password Cabling Connecting Fibre Channel portsCable length Cable type Cable size Connector Removing the FibreCenterData transfer when setting up zones Configuring the Atto FibreCenterZone 2 and Zone Hub ports Invalid Switching PatternsCLI command conventions Command Line Interface use and guidanceTelnet session Screen Symbol IndicatesExplanation Ethernet and Telnet configuration commands Status Diagnostic commandsVersion Configuration commands Setup command Switch modelUpdating firmware Linux Kernel UpdateFlash File System FFS Update Type reboot and hit Enter at the bash# promptIf LED is illuminated If LED is not illuminated TroubleshootingCondition Command Default Example Index Command Line InterfaceCanadian Standards Appendix a Standards and compliancesEuropean Standards Declaration of Conformity Appendix B Contact Atto Technology, Inc